Installing metric studs in D44 hubs?
07-10-2006, 12:44 PM
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Apr 2003
Location: Lodi, Ca
Posts: 145
Likes: 0
Received 0 Likes
on
0 Posts
Installing metric studs in D44 hubs?
Ok This is for all you Dana 44 SAS guys who swapped out your SAE threaded studs to Metric.
I'm Looking to verify what size of drill bit to use to drill the hub out to allow the installation of the dorman 610-264 studs?
I was thinking of using a 35/64?
Thx
I'm Looking to verify what size of drill bit to use to drill the hub out to allow the installation of the dorman 610-264 studs?
I was thinking of using a 35/64?
Thx
Thread
Thread Starter
Forum
Replies
Last Post
whereAreMyPants
86-95 Trucks & 4Runners
2
07-22-2015 03:32 AM
