Interior Screws?
#1
Registered User
Thread Starter
Join Date: May 2017
Location: Colorado
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Interior Screws?
I have an 88 4Runner that is missing most of the dash screws, all of which seem to be the same size? Anyone have a diagram or know what size these screws are so I can get a bucket of backups?
#2
Registered User
I think I used #10 x 3/4" and #10 x 1/2" when In reassembled my dash parts. Used a few #8 size as well. I bought a variety pack of car trim screws from Ebay before I started. Worked great as dash is tight and rattle free.
Last edited by JoeS; 12-03-2022 at 12:09 PM.
The following users liked this post:
MooseRunner (12-01-2022)
#4
YT Community Team
Yep, I even wander over to the Toyota passenger cars from the 90's and remove all the decent screws and yellow bolts that I can easily access.
Wish I had been more cognizant of JIS ages ago. Would have buggered up less screws.
I've bought a few aftermarket screws early on for the interior. They're never quite the same. Though, if the hole has gotten slightly hogged out than the aftermarket ones sometimes are the better choice.
Wish I had been more cognizant of JIS ages ago. Would have buggered up less screws.
I've bought a few aftermarket screws early on for the interior. They're never quite the same. Though, if the hole has gotten slightly hogged out than the aftermarket ones sometimes are the better choice.
Last edited by Jimkola; 12-03-2022 at 07:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post
WTT[PacNorWest]: Trade inclinometer for very good condition dashpad
881stgen
Vehicles - Parting Out
0
06-05-2018 07:40 AM