Time for new cv joints, possible upgrade?
#21
http://www.downeyoff-road.com/Engine...ents/index.htm
the bottom of the page?
regular u-joints would be a pain on the highway though...
anyone else have info on this?
the bottom of the page?
regular u-joints would be a pain on the highway though...
anyone else have info on this?
Last edited by dfoxengr; 06-13-2006 at 06:16 AM.
#22
anyone?
ill make and test some slip shaft CV's if i can get all the info down...
front CV's do turn when in 2wd though right?
manual hubs would disengage them from spinning at all correct?
ill make and test some slip shaft CV's if i can get all the info down...
front CV's do turn when in 2wd though right?
manual hubs would disengage them from spinning at all correct?
#26
that is true i suppose. but if persay you were on a flat part of a trail and were driving faster, the ujoints would probably make a lot of noise, unless you got out and unlocked the hubs, which would be annoying.
#27
anyone have a set of CV's they wont be using for awhile? i will modify them with a reinforced slip spline shaft for free, then you would just need to test them for me.
probably 1-2 weeks turn around time.
probably 1-2 weeks turn around time.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
Vargntucson
95.5-2004 Tacomas & 96-2002 4Runners
0
07-04-2015 12:15 PM