terrytcl

Looks like I'm getting my Supercharger back from Magnuson before the weekend.

I've got a pair of new intake manifold gaskets and would like to replace the existing ones. I figure I would clean up the intake manifold of all of the oil deposits too. Does anyone have the torque and tightening sequences for the 3.4L intake manifold? It would help me a lot!



Also, I'm trying to replace the antenna on my 4runner. I was able to remove it from the fender, but now I can't find the other end where I can disconnect the cable. It goes behind the fender and disappears somewhere in the engine bay. For the life of me, I can't find where it's disappearing to.
Has anyone replaced their stock antenna? I believe my 4runner came from the factory with the power model, but for some reason, the prior owner replaced the power one with a cheezy pep boys non-power model. I'm trying to put a power one back in. Any help is greatly appreciated!

terrytcl

anyone?

rimpainter.com

Check out the tech section regarding the antenna. Bob has a good write-up.

SLC Punk

The antenna goes through the fender and into the cab. You will need to take out your glove box and stereo. The you can follow the wire and take it out.

For the torque spece pm or email Gadget.

FattyCBR

For torque numbers are you asking about the long ones holding the SC to the plenum? If so they're 12 ft/lbs, I've never used any particular order with them, just make sure you work them tighter in several stages.