wildcatsrock

Hey guys new to the forum and I guess you get tired of this one but here goes. I'm going to do a 2.5 lift on a 91 4runner SR5 V6 that has 31" X 10.5" X 15's on it. I want to use the stock 15" mags and put on some 33's. I wanted some suggestions for the lift kit and will I have any trouble with the 33's rubbing? Any reccomendations for tires would be helpful. Not going offroad much it's more for looks. I have been looking at Continental Sprotiva AT's. Anybody been using them. I appreciate any help you can give me. These 4X4's ain't my thing. I'm an old school muscle car drag racer. This is for my kids truck!

4Crawler

iTrader: (3)

See below for some ideas:
- http://www.4crawler.com/4x4/ForSale/...it.shtml#FAQ10

Lumpy

This will help as well. And if your not sagging too much 33's will fit on stock.

https://www.yotatech.com/forums/f116...-guide-155339/

4Ruster

I used to run a 92 4runner that ran with Bj spacers and ome cruiser coils. 33x12.5 Goodyear Mt/r only rubbed at full lock,all i did was trim the lower bumper.

wildcatsrock

Thanks for the help guys. I looked into the Continental Sportiva's and was told that they were produced for STS and some other chains and are no longer available. I was told that they were reasonable and worked well. Does anybogy have any treccomendations? I might consider 33" X 10.5" X 15" as well as the 33"s.
Thanks again.

travismillward

i have a 91 on some after market wheels running 32x11.50x15's the wheels offset stick out a bit more than the stock wheels (i want the stock wheels) and this causes to rub sometimes in reverse, i have no lift.