Please note that the email server is about 1 to 2 hours behind, so please do not create a second account while waiting for your registration letter to arrive
Welcome to Yotatech!
Welcome to Yotatech,
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
Well Ive been running around gathering parts I think I going to need to accomplish swapping this into my 94 4runner and was hoping somebody could give me a little feedback..
So far I have the 4.7L engine/auto tranny/transfer case out of a 04 Tundra. All engine bolt ons are there and connected via the engine harness which goes thru the firewall to the ecu. I believe I still need the following before starting the engine is a reality...
1.electronic gas pedal and associated wiring
2.4wd control module and hi/lo button
Not too sure about the following...
3.TVIP (Toyota Vehicle Intrusion Protection) ECU
4.Fuse box(s) from tundra
5.vacuum modules
I will be using a Ford HP Dana 44 (driv. side diff) to match the t/case output. Also I got front leaves out of an 84 FJ60 and was wondering if anyone has used these in a SAS. They measure 42" from eye to eye and are 9.25" at highest point. I figured they'd work to support heavier cast block.. ANy Thoughts are greatly appreciated!!!
This ad is not displayed to registered members. Register your free account today and become a member on Yotatech!
__________________
95 4runner 3.0 auto limited 33-12.5-15 intake mod and lift 4.88 stock
94 project 4runner 4.56 stock everything but not for long.. both green:)
02-11-2008, 07:19 AM
Similar Threads
