Revised 3VZ-E Connecting Rod Bolt Tightening Procedure
#1
Registered User
Thread Starter
Revised 3VZ-E Connecting Rod Bolt Tightening Procedure
I found a bunch of old(and new) Toyota TSBs today. While reading through them I stumbled upon this one that was a bit of a shocker. Having recently rebuilt my engine without any clue as to it's existence. Thus not following the revised procedure for tightening the connecting rod bolts it describes when I did so.
All I can say for myself is that I followed the 93 FSM to a T. However, for reasons I can't fathom, the 93 FSM is...well...WRONG!!! Somebody please tell me how an FSM from 1993 doesn't have the correct info, when this TSB was released in 1990?
http://www.toyotapart.com/PLASTIC_RE...T-EG019-90.pdf
Page EG2-120 from the 93 FSM.
http://personal.utulsa.edu/~nathan-b...ne/69cylin.pdf
Now I know my connecting rod bolts are probably too loose. Awesome! Great job!
All I can say for myself is that I followed the 93 FSM to a T. However, for reasons I can't fathom, the 93 FSM is...well...WRONG!!! Somebody please tell me how an FSM from 1993 doesn't have the correct info, when this TSB was released in 1990?
http://www.toyotapart.com/PLASTIC_RE...T-EG019-90.pdf
Page EG2-120 from the 93 FSM.
http://personal.utulsa.edu/~nathan-b...ne/69cylin.pdf
Now I know my connecting rod bolts are probably too loose. Awesome! Great job!
Last edited by MudHippy; 02-09-2012 at 04:43 PM.
#3
Registered User
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
TJWilly
95.5-2004 Tacomas & 96-2002 4Runners
6
07-31-2015 02:05 PM
v_man
86-95 Trucks & 4Runners
14
07-23-2015 04:01 PM