New front crossmember
Jun 17, 2006 | 03:48 AM
#1
Thread Starter
Registered User
Joined: Nov 2004
Posts: 868
Likes: 1
From: Ameliasburgh, On. Ca.
New front crossmember
I decided it was about time to replace what the factory decided was a "good" design, to what I figured should be there!
What it looked like....Sorry for the crappy picture...
After I removed it....
The tube I used.... 2"x2"x1/4" thick cut to 27 1/4" long....
Here is what It looks like now!!!!
The holes were already drilled in it (it was scrap from work)
I think I'm going to redo the braces for the skid plate... I don't like them.....
Next is some more diamond plate for the skidplate....
Stay tuned for more mods (winch plate/sliders/tire carrier)
What it looked like....Sorry for the crappy picture...
After I removed it....
The tube I used.... 2"x2"x1/4" thick cut to 27 1/4" long....
Here is what It looks like now!!!!
The holes were already drilled in it (it was scrap from work)
I think I'm going to redo the braces for the skid plate... I don't like them.....
Next is some more diamond plate for the skidplate....
Stay tuned for more mods (winch plate/sliders/tire carrier)
Thread
Thread Starter
Forum
Replies
Last Post
FS[GreatLakes]: Toyota collection part out
88sasturbotoy
Axles - Suspensions - Tires - Wheels
3
Jan 30, 2026 01:57 PM
Steven.m.paulk
86-95 Trucks & 4Runners (Build-Up Section)
3
Jul 24, 2015 01:44 PM
