I'm putting a mt flywheel on an engine that was from an automatic 4runner. Do I still use the plates that went behind and in front of the flexplate? One has the guide pin thing to line it up on the back of the crank, the other just goes on front of the flexplate.

 

i dont know, however i would think if they are spacers, you dont need them... i have 2 -22rs, and have removed both flywheels, both manual trans, and there were no spacers or anything......

 

sorry to highjack no use makin a new thread i need a new clucth i was going to go with a marlin but my mom thinks a cheap one from napa etc will work fine i dont think it will you take all that time to get it why not use a good one and have the job done right the first time ?