Not sure where to post so I thought I would be safe and post here.
Question:
I would like to build a welding table that would have the welder under it, If the top is covered, can anyone see a problem having a set up like this?

Welder = Wire feed.

 

I don't see a problem at all.
I have a setup kind of like that here at my shop.

 

Only if you plan to move the table around alot. But if it's pretty much sationary and you can cover your machine from slag and crap, I say go for it.

It's usually not a good practice, but alot depends on your setup too.


HTH,

Jutty

---

 

That sounds OK to me. This could be in the fab shop section maybe...

 

Cebby, Feel free to move it over to the fab shop.

Yes I plan to have it on wheels and also plan to have a "table top" over it.

Thanks for the help

 

Moved...

 

I'd put the welder on a separate cart from the table and wouldn't keep it "under" it...just my 2 cents. I've got lots of buds that weld and all of them have their welder(s) and most of them have more than one on carts and separate welding tables.