Hey Team,

Just finishing up my header install/timing belt swap/knock sensor replacement on my 3vze (it started!), and now I need to get some heat shielding on the passenger side for the floor board and some of the other lines etc. that are in the area. I'm looking at this clamp-on solution from Thermo-tec, I like that it has room for hot air passage between the shield and the pipe:


Has anybody used this in any application? Doesn't need to be specifically this one, muostly curious if anyones actually installed it and can attest to durability, effectiveness.

Truck is a 95 hilux, 3vze, MT and 4wd.