So I got bored waiting for my block which is dangerious. Sooo I started by porting and polishing/gasket matching my intake.







Still not tired. And knowing i'm running a Big bore throttle body and EGR block off, I turned the intake over, and removed that stupid hump, blocking the intake or earlier models... I have only seen a few pics of it done, I think it turned out ok. Wish I had a better die grinder/dremel. Brillance or idiocy, its done. Comments?

 

very nice , I need to do that to mine

 

I started with a hole saw and a drill press whick removed a lot of it. Then a die grinder/Dremel

 

Well no one can say your lazy.

So How long did that take to maybe gain 1/2 a horse power??

 

Using the hole saw. maybe 1 1/2 hours. Not to bad. Being bored helps.