Hello all, new to the forums but long time Toyota enthusiast. I have an '85 extra cab that I am semi restoring and making into a daily driver that I can go out and play on the weekends with. I'm now at the point of installing a factory cruise. I've gotten all the parts I need but I didn't get a pigtail with my cruise actuator.
So I'm hoping somebody out there has an 86 runner with factory cruise that would be willing to take a pic of the connector so I can see what color wire on the body side goes to what color wire on the actuator side. I found a pigtail that plugs in but the colors are all wrong so it would be nearly impossible to wire up correctly without a bunch of trial and error wire swapping.
All help is much appreciated!

 

I need to look if any of the trucks still have it you can have the whole thing if you want it.

I know the 4runners got scrapped long ago.

Just about the first thing to go If I had cruise I would have fallen asleep and drove in the river years ago.

looking at your plug with the latch to the top

#1 is on the top2 is to the left 3 is on the right

#1 is a Brown wire

#2 Green/ red

both #1 and 2 go to the cruise control computer

#3 Yellow green going to the cruise control stop switch after the switch it is going to the cruise control computer yellow Red

Right out of the 86 EWD if you need more feel free to PM me

 

Thanks! That should be what I need. I hope to work on getting that functional in the next few days. Next will be getting the A/C going. Trying to fit everything under the hood with a 7M in there takes a fair bit of creative engineering!

 

Also one quick question, am I looking at the body end or the actuator end. And terminal side or wire side? Thanks again.

 

If you pulled the connector apart looking at either side as long as the latch is on the top

like you are going to plug it back together

 

Thank you very much. I hope to get it going before I go on a fishing trip in two weeks.

 

Success!
Everything works. I kinda had a duh moment when I started wiring it. I had been using Mitchell for my diagrams but when I actually started into this little project I brought out my TSRM. This is when I found pin-outs for everything. Thanks for the help though!