I know it can be done as I did my research and I'm referencing this thread here.

https://www.yotatech.com/forums/f2/4...bs-axle-39001/

I need custom spacers. Anyone got a picture of these spacers or should I just wing it. I have never done rear axle servicing or building so I'm in new territory. If all I need is some 3" exhaust tubing to slide in there and give the axle seal something to sit against I can do that. Otherwise I will take it to a machinist and have some made.

I'm putting an elocker housing and elocker under my 4runner but the elocker housing was bare. I've got 247k on my parts so I'm going to build this new axle with new parts except for the rear axle shafts.

Advice and wisdom appreciated.