Engine stand, tubing bender stand
Jan 30, 2012 | 07:12 PM
#1
Thread Starter
Registered User
Joined: Jul 2009
Posts: 832
Likes: 0
From: Eastern NC
Engine stand, tubing bender stand
Since the runner has been out of the garage for a bit, I have been taking some time to make the garge a little more user friendly.
The pro tools HMP 200 tube bender I have is really heavy and hard to deal with unless it is mountd to something. So I built a little rack for it.
Tonight I decided to do something with the janky HF engine stand. It always bothered me that you can't put a drip pan under it. And it was very noisy to move around. Not to mention week. It's not done, hopefully this week I'll get the time to finish it.
Later
The pro tools HMP 200 tube bender I have is really heavy and hard to deal with unless it is mountd to something. So I built a little rack for it.
Tonight I decided to do something with the janky HF engine stand. It always bothered me that you can't put a drip pan under it. And it was very noisy to move around. Not to mention week. It's not done, hopefully this week I'll get the time to finish it.
Later
Thread
Thread Starter
Forum
Replies
Last Post
DrZero
General Vehicle Related Topics (Non Year Related)
18
Jul 24, 2015 11:31 PM
