Any way to have slip-off rotors on TG front axle?
May 4, 2011 | 07:37 AM
#1
Thread Starter
Registered User
Joined: Oct 2010
Posts: 44
Likes: 0
From: Arlington, Washington
Any way to have slip-off rotors on TG front axle?
I was originally planning on using the Tacoma rotors with IFS hubs so i could have slip off rotors on the axle I was building for my 4Runner. I had a set of old IFS hubs machined slightly (cost $15) to fit, and bought some Tacoma rotors. Seemed like a number of people were having good results with this swap.
Fast forward to now, I gave up trying to find a straight, unbent front axle, and bought a pair of TG Rock Assault axles.
The only problem now, is the TG axle is 3" wider then a stock axle, so I have to use my old solid-axle hubs, to keep it at the proper IFS width.
My question is this - Is there any way to run slip off rotors with the stock solid axle hubs? Anyone ever messed with this?
Fast forward to now, I gave up trying to find a straight, unbent front axle, and bought a pair of TG Rock Assault axles.
The only problem now, is the TG axle is 3" wider then a stock axle, so I have to use my old solid-axle hubs, to keep it at the proper IFS width.
My question is this - Is there any way to run slip off rotors with the stock solid axle hubs? Anyone ever messed with this?
Thread
Thread Starter
Forum
Replies
Last Post
FS[GreatLakes]: Toyota collection part out
88sasturbotoy
Axles - Suspensions - Tires - Wheels
3
Jan 30, 2026 01:57 PM
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
Oct 19, 2015 05:28 PM
