Can anyone tell me the countersunk, flat head bolt size that I need to get for a front e-locker.
I was wanting to order the bolts now and I don't have the stock one in front of me to measure.
Thanks in advance.
Here is what I'm talking about.

And yes, I have searched and can't find it.




Pictures stolen from SeaBass

 

I can't remember; sorry. I'm guessing that it was either an M10 or M12 x 20mm. I used an allen-head as shown in this thread (post #2):

https://www.yotatech.com/forums/f115...switch-155297/

 

I just found another reference to this bolt, but the length is vague.

http://home.4x4wire.com/erik/diffs/c...more_email.htm

 

I found some more info.
Not thread specs, but you can use the screw from the Toy door jambs or 4-runner tail gate latches.

Post 29
http://www.pirate4x4.com/forum/showthread.php?t=212065

 

Yo Danny! When's the locker gonna be done? we gotta go wheelin'!

 

I'm hoping to have it wheelable again by April/May.
I have a TON of stuff to do to it this winter.
http://frontrange4x4.com/forums/showthread.php?p=76102
Winch,
Bumpers,
E-lockers,
Axle Rebuild,
Crossover steering,
OBA,
Dual trannys,
Dual Batteries,
Upgrade alternator.

BTW, Meg doing any better?

 

go to ace hardware, i take hardware there and they can tell pitch and length by looking at it. i would get 8.8's you dont know the metal that was used for that door jamb screw