Notices
86-95 Trucks & 4Runners 2nd/3rd gen pickups, and 1st/2nd gen 4Runners with IFS

Topping up my brake resevoir

Thread Tools
 
Search this Thread
 
Old Apr 1, 2008 | 01:57 AM
  #1  
skinnadoor's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 122
Likes: 0
From: Comox Valley, British Columbia, Canada
Topping up my brake resevoir

Hey folks,

This may seem a bit lame, but my brake resevoir is at the min, and i was wondering if it's ok just to open the resevoir and top it up without comprimising my brake system.

Just take the cap off, fill to max and i'm good to go??

For some reason i was under the impression that i would lose brake pressure if i opened the resevoir.
Reply
Old Apr 1, 2008 | 02:24 AM
  #2  
rdlsz24's Avatar
Registered User
 
Joined: Sep 2005
Posts: 1,481
Likes: 6
From: Northern IL
Yep that is fine. The only way you are going to suck air into the system is if the reservoir were empty and then you stepped on the brakes.

Rob
Reply
Old Apr 1, 2008 | 05:34 AM
  #3  
PCE91V64x4's Avatar
Registered User
 
Joined: Dec 2007
Posts: 248
Likes: 1
From: Cincinnati
Your brake fluid is low either due to brake pad wear or a leak. It is a good idea to keep the reservoir full, but you may want to check your pads as they may need replacing.
Reply
Old Apr 1, 2008 | 05:35 AM
  #4  
crackerjack's Avatar
Contributing Member
 
Joined: May 2006
Posts: 618
Likes: 0
From: cookeville tn.
I kept putting in brake fluid and then while wheeling it would spill out around cap. I finally just left it half full and put a ziptye around cap....so far so good
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jasonty
Pre 84 Trucks (Build-Up Section)
41
Dec 23, 2018 01:00 PM
CanRunner
95.5-2004 Tacomas & 96-2002 4Runners
6
Jul 20, 2015 01:29 PM
87turboPA
86-95 Trucks & 4Runners
2
Jul 12, 2015 07:49 AM
crashburnoveride
86-95 Trucks & 4Runners
1
Jul 10, 2015 06:39 AM
87turboPA
86-95 Trucks & 4Runners
0
Jul 9, 2015 05:58 AM




All times are GMT -8. The time now is 08:15 PM.