I want to leave my license plate in stock location and love the looks of the Warn rear bumper, but not the price. Has anyone been able to fab something up along those lines?



BTW I hate tubes

 

i am gonna make one outa 2x4 square tubing and just cut up the sides at an angle and add some recovery pts. All in all it should only cost me 50 bux or so, depending on the bracket situation.

 

I like that bumper, but I would really like something that looks similar to that, but wraps around the sides like my ARB does on the front. I just need someone to make it for me.

 

See this thread.
https://www.yotatech.com/forums/show...mper+build+off


there are two different types on there. One with the side protection and one without. : )

 

How bout a front? I love the front but have no intent on spending $700 for a bumper...

 

I made one similar to Robs (WATRD's). Although I am sure my welds are not as clean! I think it cost around $75 or so to build (at a shop where I didn't need to worry about gas, elec, wire, etc). I am very happy with it.