3.4 Swap wiring information needed!
#1
Registered User
Thread Starter
3.4 Swap wiring information needed!
Well, here goes. I'm about to take the plunge into the world of the 3.0 to 3.4 swap. I found a complete engine, with ECU, wiring harness, and everything else I need from a 97 Taco w/5 speed. I'm putting it into my 91 4Runner, 5 speed, and I have the FSM for the 4Runner. What I need is the wiring diagrams from the 97 Taco, and yes, I know all about the Toyota TechInfo site, but I'm a Canadian and the website only supports American addresses for the credit card info.
So, I pray that one of you fine folks who have done the swap can help me out with some info on what to swap and the best way to do it. I've read Andy Zook's page, CORunner's page, and about every other page I can find online, but I really need the pinout diagrams. Please, if anyone can give me a hand with this, I would be eternally grateful.
Thanks,
Rob
So, I pray that one of you fine folks who have done the swap can help me out with some info on what to swap and the best way to do it. I've read Andy Zook's page, CORunner's page, and about every other page I can find online, but I really need the pinout diagrams. Please, if anyone can give me a hand with this, I would be eternally grateful.
Thanks,
Rob
Thread
Thread Starter
Forum
Replies
Last Post
FS[PacNorWest]: T100 auto trans/tcase - Bay area, CA
94whiterunner
Engines - Transmissions
2
09-22-2015 07:25 PM