Which way is up? copper cylinder Head Shim!
#1
Registered User
Thread Starter
Join Date: May 2004
Location: Clarkston, Mi
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Which way is up? copper cylinder Head Shim!
Hey Peoples! LOL! Any of ya ever use a Copper shim with a headgasket on a 22RE? Does it go between the block and the Headgasket or the Cylinder Head and the gasket?
Thankyou Thankyou!
Rick
Thankyou Thankyou!
Rick
#4
Registered User
Thread Starter
Join Date: May 2004
Location: Clarkston, Mi
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
ended up ordering a thicker head gasket. yeah the head was machined a few times. the thicker gasket brought it to within .003 of factory thicknes.
decided not to use the shim becuase I figured two gasket surfaces was better than 4 or 3 depending on how you think about it.
decided not to use the shim becuase I figured two gasket surfaces was better than 4 or 3 depending on how you think about it.
Thread
Thread Starter
Forum
Replies
Last Post
kgcwb44
86-95 Trucks & 4Runners (Build-Up Section)
4
01-29-2023 10:02 AM
Blamalam
86-95 Trucks & 4Runners
22
03-12-2022 07:34 AM
Iceman4193
86-95 Trucks & 4Runners
28
08-28-2015 08:43 PM