Getting Seat Belts to release
#1
Getting Seat Belts to release
I recently picked up a set of retractable seat belts out of an 85 Standard cab that I would like to use in the backseat of my '81 Trekker. The belts functioned fine as far at retracting and extending at the U pull it junkyard. After taking them out I must have let them retract too far, they both have got about 4 feet of belt out side of the housing. I have tried pulling on it etc to get them to extend again, is there some trick to getting them to release again?
Thanks, Robb
Thanks, Robb
#2
You have to make sure the belt housing is level. It has a pendulum inside that locks it in place. When it is level it should release?
Last edited by lobody94; 03-23-2008 at 04:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Badfish740
86-95 Trucks & 4Runners
4
09-04-2015 04:21 AM