symptoms of a blown clutch?
#22
Registered User
iTrader: (5)
I hope the flywheel will be ok. When I rebuilt the motor and put in the new clutch, the machinist at my work took mine and just swapped it out for a newer one that was already resurfaced.
I posted this thread a little while ago because I had an oil leak after the fresh rebuild.
https://www.yotatech.com/forums/f116...g-pics-231579/
I've come to the conclusion that it is either the rear main seal or the trans seal. I am going to replace both while I'm in there any way (especially since I used the cheap seal that came with a 350 dollar full rebuild kit)
I posted this thread a little while ago because I had an oil leak after the fresh rebuild.
https://www.yotatech.com/forums/f116...g-pics-231579/
I've come to the conclusion that it is either the rear main seal or the trans seal. I am going to replace both while I'm in there any way (especially since I used the cheap seal that came with a 350 dollar full rebuild kit)
Just curious.... did he say he balanced that flywheel to your new motor and clutch? ....Mine was resurfaced but also balanced after the rebuild and new crank was installed. (I'm not saying they did something wrong, I'm still learning and thought I'd ask. From what I understand, balancing the flywheel with the crank is important, especially if it's been resurfaced???) <<< Lemme have it, Big Mike! hahaha. Honest, I can take it, lol.
#23
Registered User
Thread Starter
no he didnt say any anything about that...lol. I hope its not important. im kinda newbie, so I dont even know the importance...
and 4runner530. I work at Riebes on 20th street in town. unfortunately, our machine shop just closed this week for good. I can recommend North State Auto Parts on park ave right by us, or Dave's Automotive machine on the north side of town. I don't really know of any one else.
we do have a machine shop in oroville, just dont know any of the guys out there.
and 4runner530. I work at Riebes on 20th street in town. unfortunately, our machine shop just closed this week for good. I can recommend North State Auto Parts on park ave right by us, or Dave's Automotive machine on the north side of town. I don't really know of any one else.
we do have a machine shop in oroville, just dont know any of the guys out there.
Last edited by skoti89; 03-29-2011 at 07:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
he's gone
95.5-2004 Tacomas & 96-2002 4Runners
7
12-03-2019 07:08 AM