sh0kk86

Just thought id start a thread that could contain a lot of info on fender clearancing/tubbing/hacking.

if this has been done before ill delete.

Reason being i want to run 37's with 4" front lift springs, with the axle moved about 2" forward when i sas. and 63" chevies with 6" shackle in rear.

I want to clearance my front fenders like this:
and

I know im going to get some flaired fiberglass fenders for sure down the line, like the yellow truck below, but want to run the stock for a while.

and my rear like this:



, but its a 4runner, and it has more room for the fuel door.

How would i go about doing this with the stock bed. ive thought about fiberglass bedsides, but dont want to go that route just yet($$$).

some pics, info, or past threads oyu guys have would be great.

these are just some of the best trucks that ive liked over the years of researching:

Attached Thumbnails

 

__________________
1986 Toyota 22r Short bed Pickup | 33x10.5x15 BFG MT's

Volcom

Here's some cut-up pics of my 84 4Runner trying to get some 40" Iroks to fit.

http://www.yotatech.com/f88/fitting-...runner-136170/

__________________
1984 Toyota 4Runner
EFI swap
TG 4" springs
Marlin Crawler Dual Ultimate Crawler
39.5" Iroks

My 4 wheel drive club
http://www.rockfrogs.org