92 4Runner Wheels
#1
Registered User
Thread Starter
Join Date: Mar 2004
Location: Vancouver
Posts: 2,171
Likes: 0
Received 0 Likes
on
0 Posts
92 4Runner Wheels
Im looking to get new Wheels for my 92' 4Runner. I am leaning towards the Mickey Thompson Classic 2 . 15x8. However they only come with a -28mm offset. My question is this going to have any adverse effects on steering or ball joints, and will the offset and the extra inch in width extend the tires past the wheel flares? If anyone has any suggestion on the M/T or any wheels it would be appreciated.
#2
Registered User
https://www.yotatech.com/forums/show...ghlight=wheels
Search isn't a dirty word.
My front tires stick out a little (1" or so), the rear fit under the bushwackers. I'll let ya know on the accelerated wear on the front end. I have 125K on it though - stuff is bound to wear out.
Search isn't a dirty word.
My front tires stick out a little (1" or so), the rear fit under the bushwackers. I'll let ya know on the accelerated wear on the front end. I have 125K on it though - stuff is bound to wear out.
#3
I was testing out my jack a few weeks ago and when I had the front wheel off the ground, it didn't turn very freely.. I'd give it a good push and it'd turn about two times around before stopping.
I think they put new bearings up front when I had my clutch replaced.. shouldn't it turn more freely then that though?
btw: I've had 15x8's on mine for two years, not sure about the backspacing but they seem to have worked ok so far.
I think they put new bearings up front when I had my clutch replaced.. shouldn't it turn more freely then that though?
btw: I've had 15x8's on mine for two years, not sure about the backspacing but they seem to have worked ok so far.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
skoti89
Off Road Trip Planning, Expeditions, Trips, & Events
0
07-06-2015 07:45 PM