Back... 3.4 swap running rough
#1
Back... 3.4 swap running rough
I did this swap a while back and had to drop the project because I was laid off and lost temporary interest. Well, things have changed and I'm back in the game..
In short: 3.4 V6 swapped into an 85 pickup...
Starts and idles fine, but once you drive there seems to be a pretty sever hesitation as if it's missing or has a lack of fuel. Once in gear it seems to almost stall until it's in a higher rmp range.
I do NOT have a full exhaust system.
My first O2 sensor is hooked up and my 2nd O2 is NOT.
When I complete my system and by pass my 2nd O2 sensor Elvota's bypass... do you think it could solve my issues?? Or maybe a back coil pack??
I wasn't quite sure what to search for? any tips would be appreciated.
In short: 3.4 V6 swapped into an 85 pickup...
Starts and idles fine, but once you drive there seems to be a pretty sever hesitation as if it's missing or has a lack of fuel. Once in gear it seems to almost stall until it's in a higher rmp range.
I do NOT have a full exhaust system.
My first O2 sensor is hooked up and my 2nd O2 is NOT.
When I complete my system and by pass my 2nd O2 sensor Elvota's bypass... do you think it could solve my issues?? Or maybe a back coil pack??
I wasn't quite sure what to search for? any tips would be appreciated.
#3
OBII works, if I remember correctly the O2 sensor was the only code that came up. I suppose, is what I am describing a sypm tom of a missing rear 02 sensor?
This is strickly a farm/rock crawler, just FYI.
not sure what you mean by open vs. closed loop. This was my first swap of any kind..
#6
In the mean time, thanks! I know my TPS sensor is well grounded, but let me put the computer back on it this week and see what I come up with..just trying to reacquainted to all this.
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM