Spinnbait

I am about to start my 3.4 swap, but some things are just not 100% clear yet.
I am pretty sure I know the answer to this....
Can I use my 3.0 flywheel and clutch setup on my new 3.4 motor?
Additionally, are the flywheel bolts from my 3.0 compatible with the 3.4?

TMZ

I used all 3.0 clutch parts on mine including flywheel and bolts.

Spinnbait

Gravy. I'm closer to getting this thing in than I thought...
I think that the wiring is the last hurdle.

RobD

I used the 3.4 flywheel, clutch and pilot bearing. I used the throwout bearing from the 3.0.

904_runner

I used a brand new kit from marlin for the 3.0..

And then had my flywheel resurfaced.

vital22re

iTrader: (2)

3.4 starter, flywheel, clutch kit including pilot, but 3.0 throw out bearing.

Spinnbait

I am going to use my 3.0 flywheel, clutch (relatively new), throw-out, 3.4 pilot and starter.
I am sure that the 3.4 flywheel is a bit bigger than the 3.0, but I would rather not purchase one if I can avoid it.