how much should i pay
#3
Registered User
Thread Starter
Join Date: Oct 2008
Location: San Marcos, CA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
i have to get the bearings heated and pressed in so im going to have to take it into the shop to do that so i was just going to have the shop do it all.
how much should that run me?
how much should that run me?
#4
Registered User
Join Date: Nov 2008
Location: Poteau, Ok
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I have no Idea on the labor side of it. That will depend on what the shops hourly rate is. I have a press at my shop so I did mine myself. All I can talk about is how much the products cost. I wouldnt think it would take more than 3 hours to do by a professional but the hourly rate can be anywhere from $50 to over $100.
Thomas
Thomas
#7
Registered User
Thread Starter
Join Date: Oct 2008
Location: San Marcos, CA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
it was $425 for one side bearing seal and wheel cylinder and they did a great job and cleaned all the grease off of everything and new pads on both sides
tnt service in oceanside california they were really good and knew what was up my friend who has a 89 pickup recomended them and they passed my test it is a toyota only shop
tnt service in oceanside california they were really good and knew what was up my friend who has a 89 pickup recomended them and they passed my test it is a toyota only shop
Thread
Thread Starter
Forum
Replies
Last Post
charlie_fong
General Vehicle Related Topics (Non Year Related)
0
09-27-2015 10:06 PM
FS[SouthCent]: TX - 4Crawler Ball Joint spacers
crash813
Axles - Suspensions - Tires - Wheels
0
09-27-2015 07:15 AM
clok
General Electrical & Lighting Related Topics
3
09-21-2015 08:18 PM