4 Wheel drive won't disengage
#1
Registered User
Thread Starter
Join Date: Oct 2008
Location: Denver
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
4 Wheel drive won't disengage
I've got a '92 Runner, I've already rebuilt the engine and the tranny. Now the 4 wheel drive won't disengage. Then, my wife drove it on the freeway and said that it was slamming. I've bout had it with this lemon of a yota. As far as I know I'm the second owner and it only has 176k on it. Should I just cut my losses or dump another chunk o' change in to it?
At this point I'd take $2000 for it
At this point I'd take $2000 for it
#2
Registered User
Your 4Runner uses vacuum to engage and disengage 4 wheel drive. On the passenger side fender, there are two VSV (vacuum switching valves) that are responsible for sliding a sleeve in and out of place to engage or disengage your front axle.
http://www.off-road.com/trucks4x4/ar....jsp?id=399612
When you did the rebuild, you may have swapped over the vacuum lines by mistake. Read that link and you should be able to troubleshoot it pretty easily.
http://www.off-road.com/trucks4x4/ar....jsp?id=399612
When you did the rebuild, you may have swapped over the vacuum lines by mistake. Read that link and you should be able to troubleshoot it pretty easily.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
skoti89
Off Road Trip Planning, Expeditions, Trips, & Events
0
07-06-2015 07:45 PM