I really want to see a good cowl hood scoop for our trucks. I have yet to see one that goes with the factory "bump". Custom seems the way to go...

I have always disliked forward facing scoops since when you go offroading tons of water get dumped right onto the top of your engine.. They look good though

I had no luck in locating a 3rd gen 4Runner scoop for less than an arm and a leg, but I did score a JDM early 90's Toyota Starlet hood with a ram air scoop on it. I needed mine to clear my 3.4 conversion, too.



I still need to do the finish work on it.

The write-up (so far) is here : https://www.yotatech.com/forums/f116...no-56k-122012/

what about welding or making this hood scoop fit our trucks? cause i might just get it and make it fit!!

http://cgi.ebay.com/ebaymotors/GM-CH...4506.m20.l1116

A STI hood scoop I think would look pretty good but haven't seen it done it could look horrible

we need a good photo shop guy here

Yeah, I was thinking of that too but went with this one!!!!

Thats the idea I was going for but with the stock hood. Take the original bump, and flare it up and make it into a cowl induction.

ah well good luck buddy