Help! New axle, brake problems
Put a new (unbent!) rear axle in my 94 4rnr, now after the brakes were bled I can 't get the brake pressure up. What's the correct procedure:
-Bleed master cylinder-got it -Bleed brake lines- them too (all 4) -Bleed LSP ang BV WHAT ARE THESE? I'm just spongy. tk |
Try this, works very well for me.
http://www.4x4wire.com/toyota/mainte...leedingbrakes/ Good luck Robb |
Thanks for the link, I'll give it a go!
|
All times are GMT -8. The time now is 08:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands