has anyone built their own center console? lets see them pics....
 

:banger::banger::banger:i am redoing the entire interior on my 1990 4runner. i was sick of looking at that tires ass old center console so i pulled it out and am planning to fabricate my own custom job. has anyone else done this and if so, share your pics!

btw...
i have a some free parts if ayone is interested. i have the stock steerung wheel minus the pad, the rear heater blower assembly complete, ashtray assembly and the 2 front stock seats. they are all in good condition email me if interested jamesrhcp@yahoo.com

Where are you located? I'm interested in the seats.

dern you junkers!! got to it before i could

https://www.yotatech.com/forums/f88/...onsole-147658/

https://www.yotatech.com/forums/f116...ations-139934/

Search term: Custom Center Console

i am in denver colorado. i might be going to albuquerue[ my hometown] next month to pick up my bumper from desert rat.

Thank you DC, I was about to :bang: , Still am but whatev...:dj:

I did the Mich mod on my center console
 

New custom console - no but I did the mich mod (Mazda Integrated Cup Holder). It looks clean and man its it nice to have two cup holders!

Cup holder unit from Mazda 3 or 5 trimmed to size of 4Runner center console.

4Runner center console interior compartment cut out on drivers side to allow cup holder lid to open

Trimmed cup holder unit epoxied into 4Runner center console compartment

4Runner top trim pieces (Yes I found a use for these) cut to fit front and back of installed cup holder unit (purely cosmetic).