Pulled a used (newer) drive shaft, what should I know?
Dec 18, 2023 | 02:28 PM
#1
Thread Starter
Registered User
Joined: Oct 2011
Posts: 52
Likes: 0
Pulled a used (newer) drive shaft, what should I know?
Hey guys, I took my 99 2WD 4runner to a local shop who told me the shaking I've been experiencing is due to the driveshaft. Today I went to a local junkyard and found a 2001 driveshaft so I'm glad it's going to be a newer component. The ends may have been dragged in the dirt though while I was pulling it from the car. Anything I should do to it before putting it on the car other than brush off the dirt? Should I grease it with anything prior to installing it? All the guides I've watched show that I should mark the thing before removing to know how to place it back, since this is from another car, how would I know how it was supposed to go back in?
Last edited by crespoh69; Dec 18, 2023 at 02:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
JaredL
84-85 Trucks & 4Runners
11
Oct 15, 2023 08:01 PM
95PhoRunner
86-95 Trucks & 4Runners
47
Jan 8, 2010 02:21 AM
