*SOLD*

$85.00 plus UPS shipping originating in Los Angeles, CA area. Paypal and U.S. only.

Finally completed the assembly of a 91 4x4 SR5 Pickup Center Console. This has both storage areas, no wasted space from the heater blower in the runners. You'll also notice this has the large pocket area rather than the smaller one with 3 holes for switches (that's how you know it's from a truck). This console was made from several different grey interior Pickups and 4runners at junk yards in order to have this completed. It was painted with duplicolor charcoal grey interior paint and waxed and metal hinge sanded, primered and painted, all parts are OEM down to the screws and the leather shifter boot.

This is the ideal console when swapping from a bench seat to buckets. I'll try to disclose all discrepancies below. But remember this is not new, but 22-23 years old! there are scuff marks, do not expect perfection although I've cleaned it up pretty well.

Lastly - I do not have a box yet, it may take a week or two or less to find an appropriate sized box.

Full view, very light scuff marks on armrest pad. There is a hairline crack in the bottom front left that has been super glued, see photo.





All latches are working and not broken



Metal hinge in excellent condition and re-painted



Shifter boot in great condition with 3 faults, however no fraying at the top where shifter knob goes. ) There is a small tear toward the bottom, a photo clearly shows it, I've since super-glued it back together and it is no longer noticeable (just wanted to show it before repair). 2) There is also a small hole toward the front top of the boot it is shown in one photo also. 3) there is a drill hole in the plastic as if someone attached something there.

 

Do you know if this would fit in a 1st gen 4Runner? If so, I'm interested and we could probably work something out so you don't have to ship it.

 

Redeth005 has one in his 1st Gen (because I've been in his rig), but I don't know if he had to drill any holes to mount it. You might want to PM him on here.

This is from his build page on Page 1. "I had to cut the shifter area in the middle compartment a bit bigger because it was off the 94 auto 4runner so i had to make space to be able to shift"

He had an auto shifter front piece, so he had to cut it out and he had the one with the blower motor, so No second storage compartment on the bottom. He also has the smaller change pocket with the 3 switches.

These are from his truck, hope he doesn't mind borrowing them until this sells.

 

Ok, thanks. I'll PM him and see.