YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: Dirt Driver
Showing results 1 to 25 of 493
Search took 0.20 seconds.
01-12-2019, 09:11 AM
Replies: 2
Views: 4,226
Posted By Dirt Driver

They're the same physical size, but I think the...

They're the same physical size, but I think the heat ranges are different. There are plenty of cross-references online. You can also spot an ignition misfire with a timing light if the 2.7 is a...
01-12-2019, 09:08 AM
Replies: 5
Views: 4,936
Posted By Dirt Driver

I hate to be a negative Nancy, but I think you'll...

I hate to be a negative Nancy, but I think you'll find that foam shredded and dragged into the HVAC sooner rather than later. I've seen mouse nests made out of steel wool and fiberglass insulation is...
07-31-2018, 06:50 AM
Replies: 233
Views: 66,579
Posted By Dirt Driver

I think it's funny how periodically this thread...

I think it's funny how periodically this thread floats back up with the same kind of "my 3VZ-E blew a head gasket" replies. You know, because it's not a bad motor...



The KA24DE was a car...
06-20-2018, 10:45 AM
Replies: 22
Views: 24,420
Posted By Dirt Driver

That's good. I didn't feel bad necroposting since...

That's good. I didn't feel bad necroposting since it will be an ongoing problem as long as these trucks are on the road.

I'm looking for some special M5 hanger studs to replace the fan motor...
06-15-2018, 05:26 PM
Replies: 22
Views: 24,420
Posted By Dirt Driver

They haven't discovered the cowl drains behind...

They haven't discovered the cowl drains behind the fenders then.
06-15-2018, 01:02 PM
Replies: 22
Views: 24,420
Posted By Dirt Driver

Hopefully the people at Toyota responsible for...

Hopefully the people at Toyota responsible for this egregious design oversight have since ritually disemboweled themselves for such a disgrace. Doubtful, but I can dream.

A previous '94 pickup of...
04-21-2017, 06:44 PM
Replies: 3
Views: 1,006
Posted By Dirt Driver

Any codes? Power to the coil(s)?

Any codes? Power to the coil(s)?
04-21-2017, 06:38 PM
Replies: 9
Views: 1,465
Posted By Dirt Driver

It says at the end of the post. '99 V6 Taco. ...

It says at the end of the post. '99 V6 Taco.

Does it stall abruptly or does it stutter at all before it quits?

Does it restart fine, but only run briefly before stalling again?
04-10-2017, 03:37 PM
Replies: 9
Views: 1,126
Posted By Dirt Driver

Changed the diff yesterday. The old one feels...

Changed the diff yesterday. The old one feels like there is too much preload on the pinion. The "new" one feels free like I would expect from a used rear end. Filled with synthetic 85w-90 and drove...
04-08-2017, 05:06 PM
Replies: 9
Views: 1,126
Posted By Dirt Driver

The wheels were bolted on and the e-brake locked...

The wheels were bolted on and the e-brake locked when I checked. :eeek: That included the spiders and axle splines, but still kind of a lot. I found a 3.42 carrier at the JY today (probably the only...
04-08-2017, 05:06 PM
Replies: 5
Views: 1,040
Posted By Dirt Driver

Got your PM and thanks. I was able to find a...

Got your PM and thanks.

I was able to find a 7.5"/3.42 carrier at the JY today and aiming to install it tomorrow. I'm still keeping an eye out for a 3.58 to rebuild, but probably going to look for...
04-07-2017, 06:49 PM
Replies: 3
Views: 1,205
Posted By Dirt Driver

I really doubt it would cause an emissions or...

I really doubt it would cause an emissions or functional problem and IMO it's very unlikely that a smog tech would go looking for the EO#. At the same time I know what those damn things cost here and...
04-07-2017, 06:28 PM
Replies: 2
Views: 1,036
Posted By Dirt Driver

When did the knock start?

When did the knock start?
04-07-2017, 06:14 PM
Replies: 9
Views: 1,126
Posted By Dirt Driver

I misjudged the backlash; it's "only" about 5/8"....

I misjudged the backlash; it's "only" about 5/8". But still, I rechecked it after changing the remaining axle bearing aaaaaannnnnddd...the noise persists.

Whatever, I'll probably hit the JY...
04-06-2017, 04:22 PM
Replies: 5
Views: 1,040
Posted By Dirt Driver

Yeah, I don't really want a whole rear end...

Yeah, I don't really want a whole rear end anyway, but figured if I had to buy one to get the chunk, then it might as well be something I can use.

I'd be interested in the 3.42 since I do a lot of...
04-04-2017, 03:21 PM
Replies: 5
Views: 1,040
Posted By Dirt Driver

7.5" rear diff w/ 3.42 or 3.58 gears

I'm looking for a 7.5" third member with 3.42 or 3.58 gears. Plain old open diff is fine. Must be in good condition. I'd also consider a whole rear axle out of an first gen Taco five-lug with ABS and...
03-30-2017, 05:37 PM
Replies: 5
Views: 1,084
Posted By Dirt Driver

I thought that's what I put down. I even Googled...

I thought that's what I put down. I even Googled before hand to see that pictures were readily available. You're right, though; typographical error on my part. The one I listed apparently cross-refs...
03-28-2017, 05:50 PM
Replies: 9
Views: 1,126
Posted By Dirt Driver

Weird rear diff noise. Axle, pinion, carrier, or?

My truck is making a weird rear end noise that I'm having trouble diagnosing.

It has started making a mild cyclic clacking/clunking, but it only does it when engine braking on right-hand turns and...
03-28-2017, 05:12 PM
Replies: 5
Views: 1,084
Posted By Dirt Driver

You need axle bearing 90363-40063. Correction per...

You need axle bearing 90363-40063. Correction per zz denis below: 903063-40068.

For some reason Toyota's parts lists separate the two between '00 and '01, but parts suppliers draw the line between...
03-18-2017, 08:51 PM
Replies: 10
Views: 1,434
Posted By Dirt Driver

Wait, what? What?

Wait, what? What?
03-13-2017, 01:19 PM
Replies: 6
Views: 854
Posted By Dirt Driver

Yeah, that could probably cause it too.

Yeah, that could probably cause it too.
03-11-2017, 08:33 PM
Replies: 10
Views: 917
Posted By Dirt Driver

No, quite the opposite. A key is there just for...

No, quite the opposite.
A key is there just for alignment and the bolt is there to provide clamping force to keep things from moving. Keys are often made of softer material so when slippage occurs...
03-11-2017, 06:48 PM
Replies: 3
Views: 805
Posted By Dirt Driver

I replaced the intake resonator today with a nice...

I replaced the intake resonator today with a nice used one and the rubber couplers were in good shape. I cleaned the MAF while in there. There was some fine crud baked onto the two sensor elements...
03-11-2017, 06:48 PM
Replies: 10
Views: 1,434
Posted By Dirt Driver

Does the washer fluid already have a lot of...

Does the washer fluid already have a lot of methanol in it? I ask because buying it and yellow HEET seems like an expensive alternative to distilled water and racing methanol by the gallon.
03-11-2017, 06:18 PM
Replies: 25
Views: 40,049
Posted By Dirt Driver

There are issues alright.

There are issues alright.
Showing results 1 to 25 of 493
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.