YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: 4Crawler
Showing results 1 to 25 of 499
Search took 0.20 seconds.
12-01-2018, 07:46 PM
Replies: 11
Views: 3,031
Posted By 4Crawler

It's just your typical 3-way switch wiring setup....

It's just your typical 3-way switch wiring setup. Common terminals on each end (one end to power and the other end to the light). Then two wires connecting the pair of output terminals to each...
07-26-2018, 03:07 PM
Replies: 26
Views: 9,838
Posted By 4Crawler

Sure, no problem there. In fact you can even...

Sure, no problem there. In fact you can even have a bonus gear. With the hubs unlocked and the case in 4L to you have 2L, lock the hubs and you have 4L. With the stock ADD setup, it's like you...
04-21-2018, 11:42 AM
Replies: 74
Views: 47,467
Posted By 4Crawler

You might pull up the shifter boots and have a...

You might pull up the shifter boots and have a look underneath and see how close the shifter is to the front of the metal plate, since 1st and 3rd gear are forward in the shift pattern.. If too...
09-04-2017, 11:10 AM
Replies: 21
Views: 24,256
Posted By 4Crawler

Had not seen the separate rubber mount parts...

Had not seen the separate rubber mount parts before, but that looks like it should work. Unless the metal parts have been damaged by the broken rubber bit allowing too much motion, replacing just the...
02-02-2016, 09:31 AM
Replies: 11
Views: 4,480
Posted By 4Crawler

The vacuum two lines from the p/s pump hook up...

The vacuum two lines from the p/s pump hook up where I have the red caps in the image on this page:
- mhttp://www.4crawler.com/4x4/CheapTricks/22RE_Engine_Pix/11.html
01-26-2016, 09:23 PM
Replies: 51
Views: 54,850
Posted By 4Crawler

Not sure about the earlier pickups, but likely...

Not sure about the earlier pickups, but likely similar with the switched ground setup. Check for 12V at the headlight connector common pin (measured to the chassis):
...
11-19-2015, 12:51 PM
Replies: 545
Views: 270,244
Posted By 4Crawler

Some tips on measuring tire clearance below: -...

Some tips on measuring tire clearance below:
- http://www.4crawler.com/4x4/ForSale/BodyLiftKit.shtml#FAQ10

In this case, a 1" x 1" (25mm x 25mm) block run around the surface of the tire could...
11-07-2015, 07:36 PM
Replies: 17
Views: 21,231
Posted By 4Crawler

Bingo, we have a winner! Not a bad drag link but...

Bingo, we have a winner! Not a bad drag link but it's cheap to make that way, they just send you a bent chunk of tubing and a pair of road ends with a spring loaded cup in the end. Best answer is...
Replies: 16
Views: 31,504
Posted By 4Crawler

Most any auto parts store should carry those. I...

Most any auto parts store should carry those. I think I bought a whole assortment of various sized caps from JC Whitney many years ago, they come in handy for capping brake lines if you need to work...
10-14-2015, 10:26 AM
Replies: 28
Views: 11,315
Posted By 4Crawler

Here's a working link to some repair information:...

Here's a working link to some repair information:
- http://www.4crawler.com/4x4/CheapTricks/Starter.shtml
Replies: 33
Views: 66,306
Posted By 4Crawler

Something to try: -...

Something to try:
- http://www.4crawler.com/4x4/CheapTricks/Starter.shtml#EasyTest

Idea is to see what voltage you read when its cold and what voltage it reads when its hot. If different, figure...
08-23-2015, 05:56 PM
Replies: 20
Views: 33,152
Posted By 4Crawler

You bet, air flow meter also has the fuel pump...

You bet, air flow meter also has the fuel pump contacts that keep the fuel pump running on the EFI engine:
- http://www.4crawler.com/4x4/CheapTricks/AFM/index.shtml#AFMtesting

Might try the fuel...
08-15-2015, 01:05 PM
Replies: 20
Views: 11,029
Posted By 4Crawler

If the current can't flow from the relay to the...

If the current can't flow from the relay to the motor, then the motor won't work. Try re-soldering all the relay connections and see if that helps.
08-15-2015, 01:03 PM
Replies: 20
Views: 11,029
Posted By 4Crawler

Relays are electro-mechanical devices. The coil...

Relays are electro-mechanical devices. The coil is the electrical part, magnetizes when current it applied and that pulls in the iron or steel contact bar (that is the click). Then the mechanical...
08-15-2015, 12:28 PM
Replies: 20
Views: 11,029
Posted By 4Crawler

Should bypass all the interlocks that the rear...

Should bypass all the interlocks that the rear key switch bypasses:
- http://www.4crawler.com/4x4/CheapTricks/RearWindow.shtml#Relay

And if the relay clicks but the motor doesn't run, then...
08-15-2015, 11:07 AM
Replies: 20
Views: 11,029
Posted By 4Crawler

Didn't have a digital camera when I did mine, but...

Didn't have a digital camera when I did mine, but just locate the up and down pins on the connector. On mine, it was pin 5-12 and 4-11 that were connected together and they are right across from...
04-26-2015, 09:17 AM
Replies: 19
Views: 31,688
Posted By 4Crawler

Try disconnecting the radio temporarily and see...

Try disconnecting the radio temporarily and see if the dome light works. And check out the dome light socket, should be constant 12v power on one side then the door or dome light switch grounds the...
04-09-2015, 07:15 AM
Replies: 741
Views: 557,958
Posted By 4Crawler

http://www.off-road.com/trucks-4x4/tech/project109...

http://www.off-road.com/trucks-4x4/tech/project109.html

Or make some custom longer suspension control arms and mounts. Allpro Offroad used to make something like that but I don't think they have...
04-08-2015, 08:55 PM
Replies: 741
Views: 557,958
Posted By 4Crawler

With 4"-5" of lift already, you might be able to...

With 4"-5" of lift already, you might be able to squeeze one spacer in, but you'll quickly run into issues with the rear pinion angle being off due to the short rear control arms. 6" lift is about...
Replies: 33
Views: 66,306
Posted By 4Crawler

"Won't turn over" as in "starter will not crank...

"Won't turn over" as in "starter will not crank the engine over" or as in "starter cranks engine over but it won't start"?

Has the fuel pump test jumper been tried?
-...
Replies: 33
Views: 66,306
Posted By 4Crawler

The Air Flow Meter does have an air flow sensing...

The Air Flow Meter does have an air flow sensing vane inside that moves and that does cause the fuel pump/circuit opening relay (Fc) contact to close:
-...
03-14-2015, 02:45 PM
Replies: 20
Views: 11,521
Posted By 4Crawler

The later model shifters are a lower and upper...

The later model shifters are a lower and upper part. The upper part is flared and filled with a rubbery material into which the lower shaft is inserted. They are thus bonded together. The rubber...
03-10-2015, 06:45 AM
Replies: 741
Views: 557,958
Posted By 4Crawler

The FJ80 Landcruiser coils give about that much...

The FJ80 Landcruiser coils give about that much lift, as noted below:
- http://4crawler.com/4x4/ForSale/CoilSpringSpacer.shtml#PanhardDropBrkt
Forum: Pre 84 Trucks
02-22-2015, 06:39 PM
Replies: 167
Views: 19,438
Posted By 4Crawler

Normally manual transmissions are non-synchromesh...

Normally manual transmissions are non-synchromesh in reverse:
- http://en.wikipedia.org/wiki/Manual_transmission#Reverse

Not sure on the W56, but it is likely non-synchro in reverse. Could be...
Forum: Pre 84 Trucks
02-22-2015, 06:04 PM
Replies: 167
Views: 19,438
Posted By 4Crawler

Not sure, there is likely some minor internal...

Not sure, there is likely some minor internal difference that maybe only Marlin knows. Model year will tell you what is should have been:
-...
Showing results 1 to 25 of 499
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.