YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: Terrys87
Showing results 1 to 25 of 456
Search took 0.19 seconds.
09-16-2018, 10:18 AM
Replies: 2
Views: 5,678
Posted By Terrys87

I have gotten bad rebuilt alternators right out...

I have gotten bad rebuilt alternators right out of the box at one time or another at all the big name stores. Find a shop that rebuilds them correctly the first time. Clean and check all...
09-16-2018, 10:00 AM
Replies: 106
Views: 10,066
Posted By Terrys87

Hello jakey poo... I am going to invest in...

Hello jakey poo... I am going to invest in electric jacks. Those mechanical jacks are a little dangerous. We have used this camper a lot this year but having to load and unload is a real pain.
...
09-16-2018, 09:56 AM
Replies: 106
Views: 10,066
Posted By Terrys87

Making some progress. It has taken me a few...

Making some progress. It has taken me a few months just to get the cab off. Finally a friend and me made it happen. This cab is heavy and the way we had to do it I would not recommend doing it. Had a...
06-24-2018, 06:31 PM
Replies: 518
Views: 35,832
Posted By Terrys87

I always enjoy seeing one getting body work done...

I always enjoy seeing one getting body work done to it. It is a rewarding experience when done. Looking great. I read you were letting the floor dry. On primer that is ok to do since you will be...
06-24-2018, 06:15 PM
Replies: 17
Views: 1,271
Posted By Terrys87

I have never gotten any codes for the Air Flow...

I have never gotten any codes for the Air Flow Meter unless you leave the cable disconnected. Only way I have ever gotten a code for the AFM. I have had some bad AFM. Test it per a Haynes Manual and...
06-24-2018, 06:04 PM
Replies: 6
Views: 811
Posted By Terrys87

I too have gotten rebuilt alternators right out...

I too have gotten rebuilt alternators right out of the box that were bad. I would have it checked out to make sure you do have a good alternator. Most electrical issues I find are from wiring being...
06-24-2018, 05:58 PM
Replies: 13
Views: 974
Posted By Terrys87

Did you knock the cable loose from your air box?...

Did you knock the cable loose from your air box? Any loose hoses that could cause a vacuum leak?
06-24-2018, 06:57 AM
Replies: 22
Views: 1,751
Posted By Terrys87

Not sure of the fast blinker issue. Those light...

Not sure of the fast blinker issue. Those light sockets can get really corroded. I would give them a good cleaning or even replace the blinker assembly and see if that helps.
Forum: Pre 84 Trucks
06-24-2018, 06:50 AM
Replies: 7
Views: 6,743
Posted By Terrys87

You dont see many of those trucks in that good of...

You dont see many of those trucks in that good of a shape anymore. Nice find.
06-23-2018, 05:17 AM
Replies: 106
Views: 10,066
Posted By Terrys87

Hello jakey poo. I am slowly but steady making...

Hello jakey poo. I am slowly but steady making some progress on the Ford. Now that I have a camper I am really trying to get my truck set up to haul it as loading it and loading it really a pain in...
06-23-2018, 04:46 AM
Replies: 106
Views: 10,066
Posted By Terrys87

Still slowly moving along. Misty got her a 97...

Still slowly moving along. Misty got her a 97 Extended Cab Silverado. I will eventually get a few dings knocked out of it and get it to where she wants it to be. She looked at umerous cars and trucks...
06-23-2018, 04:15 AM
Replies: 13
Views: 838
Posted By Terrys87

Nice looking runner. To pull the dent out I would...

Nice looking runner. To pull the dent out I would remove the tail light and use a pry bar to help push the dent out. The curved part of a pry bar might get in behind it to help get it started to move...
06-23-2018, 04:10 AM
Replies: 2
Views: 928
Posted By Terrys87

If your washer fluid tank has a hole in it you...

If your washer fluid tank has a hole in it you will just have to replace it. I am betting your leak is at the washer fluid pump. The seals or the pump has just disintergrated. I get my washer pumps...
06-23-2018, 04:05 AM
Replies: 5
Views: 996
Posted By Terrys87

93 has the electrical driven speedometer. I think...

93 has the electrical driven speedometer. I think there is a sensor that can be replaced to fix that. I am not as strong on the 92 and newer trucks.

As far as your fuel gauge, the float in the...
06-23-2018, 04:00 AM
Replies: 11
Views: 876
Posted By Terrys87

On the green box in the above picture has always...

On the green box in the above picture has always been the culprit to be the reason for wiper delay not working on my trucks. Pull the green box and see if it has a melted case on the back side. It...
Replies: 35
Views: 8,820
Posted By Terrys87

Great looking little truck you found. I too like...

Great looking little truck you found. I too like the steel wheels. There is a chrome ring and a black center cap that goes on the rims that I think make the wheels look even better.

After a truck...
05-31-2018, 02:47 AM
Replies: 5
Views: 744
Posted By Terrys87

When I have clutch issues as you are describing,...

When I have clutch issues as you are describing, I replace both the Master and Slave Cylinders at the same time. You can replace the faulty component but usually the other one will eventually fail....
05-31-2018, 02:43 AM
Replies: 27
Views: 1,809
Posted By Terrys87

I have never had a bad COR. 22re and 3.0 share...

I have never had a bad COR. 22re and 3.0 share the same operations. https://www.yotatech.com/forums/f116/3-noid-light-22re-270857/ If you are suspecting your injectors, a continity test is not always...
Forum: Pre 84 Trucks
05-31-2018, 02:34 AM
Replies: 18
Views: 7,163
Posted By Terrys87

Congratulations!!! The Weber makes life so much...

Congratulations!!! The Weber makes life so much easier and working on these trucks. Once you get everything set, a couple of pumps of the throttle and the truck will fire up fast, usually with one or...
05-31-2018, 02:31 AM
Replies: 1
Views: 630
Posted By Terrys87

Truck sat for 4-5 years? Did you just put a...

Truck sat for 4-5 years? Did you just put a battery in and crank it right up? It is always exciting to here a motor fire up but if it has sat for that long, I never just crank one over. I soak the...
05-31-2018, 02:24 AM
Replies: 13
Views: 7,194
Posted By Terrys87

Look into corrosion around the socket, Mine would...

Look into corrosion around the socket, Mine would not work until I got all of the corrosion off. I used some electrical contact and a wire brush to get mine working.
05-31-2018, 02:21 AM
Replies: 8
Views: 893
Posted By Terrys87

700 sounds like a good deal if it was done right...

700 sounds like a good deal if it was done right but that is a big IF. I have ordered motors on line for a little more then $1000 just have to search around. Rebuild one has cost me more then...
05-22-2018, 12:14 AM
Replies: 2
Views: 424
Posted By Terrys87

Welcome to Yotatech. Looking forward to seeing...

Welcome to Yotatech. Looking forward to seeing some of your trucks.
04-22-2018, 11:37 AM
Replies: 6
Views: 462
Posted By Terrys87

Welcome to Yotatech. Got any pictures? Tons of...

Welcome to Yotatech. Got any pictures? Tons of information on here to guide you thru.
04-22-2018, 11:33 AM
Replies: 9
Views: 433
Posted By Terrys87

I get my plugs, rotor, and cap from the dealer...

I get my plugs, rotor, and cap from the dealer ($43 dollars total from dealer). They are about the same price as the part store and much better quality. Stay factory on the plugs NGK or Denso. I get...
Showing results 1 to 25 of 456
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.