YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: vital22re
Showing results 1 to 25 of 387
Search took 0.18 seconds.
10-03-2018, 06:41 PM
Replies: 5
Views: 1,265
Posted By vital22re

if its going on a v6 truck 90% sure they will not...

if its going on a v6 truck 90% sure they will not clear the calipers in the front.
Forum: Engine Swaps
10-03-2018, 06:37 PM
Replies: 6
Views: 885
Posted By vital22re

You will need to run a T-100 ecu from an early...

You will need to run a T-100 ecu from an early 3.4 equiped truck. You will also need to run an extra relay to control the L4 on your truck as the 3.4 vehicles didn't have a married Tcase to the...
10-03-2018, 06:30 PM
Replies: 12
Views: 2,151
Posted By vital22re

Yes to all. If anyone has messed with any screws...

Yes to all. If anyone has messed with any screws on the throttle body or if the dashpot is keeping the throttle from returning all the way that could happen. What is your idle and timing?
Forum: Engine Swaps
09-18-2018, 09:45 PM
Replies: 6
Views: 885
Posted By vital22re

3.4 swap is by far the easiest swaps. There is...

3.4 swap is by far the easiest swaps. There is an entire section here devoted to it. And its by far a more reliable engine. Much easier to work on.
09-18-2018, 09:41 PM
Replies: 22
Views: 7,124
Posted By vital22re

I know its dumb. But how you have the intake and...

I know its dumb. But how you have the intake and the few vacuum hoses connected does matter. As you saw by changing your intake, if its not exactly like factory, it may throw a fit. Check the...
Replies: 1
Views: 628
Posted By vital22re

the mounting changed. Atleast in the 2uz thats...

the mounting changed. Atleast in the 2uz thats in landcruisers. It went from a bolt and a stud, to a bolt and 2 studs I believe. 2 mounting points to 3.
09-08-2018, 08:16 PM
Replies: 6
Views: 711
Posted By vital22re

Of the 5 or so 2L series motors that have come...

Of the 5 or so 2L series motors that have come through our shop (in prado's) 4 have had cracked heads.
The wiring isn't terrible. You could always outsource just the wiring. But you could...
Forum: 3.4 Swaps
09-06-2018, 07:17 PM
Replies: 8
Views: 1,414
Posted By vital22re

It all depends on what brand clutch you get. The...

It all depends on what brand clutch you get. The early clutch disks and covers were designed with the springs were about 70% of the way protruding out of the disk. That style clutch disk needed to...
09-06-2018, 07:09 PM
Replies: 6
Views: 711
Posted By vital22re

No!

Avoid the toyota 4cyl diesels unless you like cracked heads and feeling slower than the 3.0.
Having done , 2rz, 3rz, and 5vz swaps. Go with the 5vz. If your truck was a 22r or 22re, then i'd say...
Replies: 2
Views: 745
Posted By vital22re

Being that its a sealed transmission, I hope you...

Being that its a sealed transmission, I hope you followed the proper procedure for the "Drain and Fill". Some of these transmissions you have to replace exactly what you took out. And there is a 3...
Forum: Computer Talk
04-09-2018, 08:33 PM
Replies: 1
Views: 484
Posted By vital22re

if its a 97, the obd2 diagnostic port is under...

if its a 97, the obd2 diagnostic port is under the dash on the driver side. Its a white connector 16 pin. The "diagnostic port" under the hood is more or less for jumping the fuel pump and for...
04-09-2018, 08:29 PM
Replies: 41
Views: 2,526
Posted By vital22re

oh you're THAT guy, blinding everyone on the...

oh you're THAT guy, blinding everyone on the road. waaaaaaaaaaaaaaaaaaaaaaaaay to go chris!
04-09-2018, 08:25 PM
Replies: 1
Views: 241
Posted By vital22re

check transmission fluid level. Also if the...

check transmission fluid level. Also if the thermostat is stuck open and the coolant is cold, it will not kick into overdrive.
Forum: 3.4 Swaps
04-09-2018, 08:22 PM
Replies: 2
Views: 864
Posted By vital22re

wiring harness. What year is the donor engine...

wiring harness. What year is the donor engine from? depending on year, some sensors and injectors were different. As well as the port layout the upper intake plenum. If you're stripping it down...
01-14-2018, 05:06 PM
Replies: 2
Views: 7,673
Posted By vital22re

should be a +12v, signal ground, chasis ground,...

should be a +12v, signal ground, chasis ground, and the signal wire from ecu.
01-14-2018, 04:58 PM
Replies: 2
Views: 366
Posted By vital22re

you need to get a scanner that can show you live...

you need to get a scanner that can show you live data. You can look at what the ECU is doing for the fuel trims, tps, coolant temp, etc.
Sometimes a sensor will read out of spec and cause issues...
Forum: 3.4 Swaps
01-14-2018, 04:54 PM
Replies: 2
Views: 1,009
Posted By vital22re

Get the TIS subscription. all the info you need...

Get the TIS subscription. all the info you need to run the ECU stand alone style is in the engine ecu diagram
Forum: 3.4 Swaps
12-13-2017, 08:37 PM
Replies: 4
Views: 2,037
Posted By vital22re

I use a 1/4" extension or a punch that fits from...

I use a 1/4" extension or a punch that fits from the inside (remove oil pan) and hammer it out. Do not heat it up as you do NOT want the plug to expand. You're other easier option, Drill out the...
Forum: 3.4 Swaps
12-13-2017, 08:28 PM
Replies: 2
Views: 793
Posted By vital22re

Or you can run all 3.0 stuff (flywheel, clutch,...

Or you can run all 3.0 stuff (flywheel, clutch, starter, throw-out bearing) Pilot bearing I think is the exact same. Be aware though that the 3.4 clutch disk and pressure plate have a bigger surface...
12-13-2017, 08:22 PM
Replies: 8
Views: 5,987
Posted By vital22re

It should not run without a maf. Unless you just...

It should not run without a maf. Unless you just have the fuel pump running with ignition on. The MAF triggers the COR to kick on which is what runs the fuel pump. Have you verified your repin to...
Forum: 3.4 Swaps
10-28-2017, 07:45 PM
Replies: 1
Views: 770
Posted By vital22re

Loosen the banjo bolt at the back of the...

Loosen the banjo bolt at the back of the passenger fuel rail.
Remove the 10m head bolt thats holding a bracket for the fuel line near the driver side fuel rail
rotate the fuel hose so it points...
10-28-2017, 07:36 PM
Replies: 3
Views: 4,190
Posted By vital22re

More than likely its the idle air control valve. ...

More than likely its the idle air control valve. I've had to replace a few on the 3.4's. You should also have a power steering idle up valve near your power steering pump on the pressure line. Make...
10-28-2017, 07:29 PM
Replies: 4
Views: 4,276
Posted By vital22re

Are you using the injectors from your motor? 99+...

Are you using the injectors from your motor? 99+ injectors are different from 96-98. High impendance vs. low.
10-28-2017, 07:27 PM
Replies: 2
Views: 632
Posted By vital22re

I believe the flat face ones are for IFS hubs. ...

I believe the flat face ones are for IFS hubs. The other ones I believe are SA ones. You'll need to use the ones that match your hubs.
10-17-2017, 06:16 PM
Replies: 13,985
Views: 900,365
Posted By vital22re

BBP bought a house, I took off my supercharger...

BBP bought a house, I took off my supercharger off the tacoma and sold it. The next day I bought a 05 gx470 2uz with vvti to shove in my 03 Tacoma instead.
Showing results 1 to 25 of 387
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.