YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: Paul22RE
Showing results 1 to 25 of 211
Search took 0.01 seconds.
06-17-2019, 01:21 PM
Replies: 5
Views: 136
Posted By Paul22RE

Does anybody have a link on how to correctly...

Does anybody have a link on how to correctly adjust this amplifier? I turned mine accidentally without making note of where it was set at.
06-17-2019, 10:28 AM
Replies: 1
Views: 107
Posted By Paul22RE

According to the '87 FSM, the 15A engine fuse...

According to the '87 FSM, the 15A engine fuse controls the "Combination Meter"
06-17-2019, 07:04 AM
Replies: 30
Views: 2,097
Posted By Paul22RE

Just checked mine, 28psi at idle after operating...

Just checked mine, 28psi at idle after operating temp is reached. I have a new OEM pump & FPR too. Would being a little below spec cause a rough idle? When I turn car off, gauge goes up to 35psi...
06-15-2019, 04:37 AM
Replies: 11
Views: 543
Posted By Paul22RE

Glad to hear it is running much better!

Glad to hear it is running much better!
06-14-2019, 03:29 AM
Replies: 11
Views: 543
Posted By Paul22RE

Have you cleaned the Throttle Body? Also check...

Have you cleaned the Throttle Body? Also check for any cracks/leaks on the intake hose leading to the TB. Also, check for any play on the TB shaft. Most thorough way to clean the TB is to remove it &...
06-09-2019, 04:56 AM
Replies: 45
Views: 2,403
Posted By Paul22RE

Here, it ended up being the COR intermittently...

Here, it ended up being the COR intermittently not working. You did hose everything down pretty good, that could wreak havoc on a relay:...
06-06-2019, 04:16 PM
Replies: 45
Views: 2,403
Posted By Paul22RE

That is the exact symptom of the VAFM plug being...

That is the exact symptom of the VAFM plug being disconnected. I agree with CO 94 that it may be electrical, the plug not making good contact or one or more bad wires in that harness.
06-05-2019, 04:40 PM
Replies: 45
Views: 2,403
Posted By Paul22RE

Why did the ECU need to be reinstalled? How long...

Why did the ECU need to be reinstalled? How long does it run before it dies?
05-29-2019, 03:45 AM
05-27-2019, 05:29 PM
Replies: 12
Views: 1,826
Posted By Paul22RE

Yes, changing the angle will put more stress on...

Yes, changing the angle will put more stress on u-joints. When is the last time they were greased? It would be more noticeable with abrupt accelerating/decelerating or shifting to/from drive to...
05-27-2019, 04:04 PM
Replies: 12
Views: 1,826
Posted By Paul22RE

Did you check the u-joints? Any clunking noise...

Did you check the u-joints? Any clunking noise when shifting to/from reverse?
05-26-2019, 05:20 AM
Replies: 13
Views: 2,788
Posted By Paul22RE

I bought from this eBay seller, they have all...

I bought from this eBay seller, they have all sizes needed for a 22RE (3mm, 6mm, 8mm & 10mm). Shipping did not take forever even though they came from the UK. Quality hoses & fit perfect, was worth...
05-22-2019, 04:48 PM
Replies: 8
Views: 2,055
Posted By Paul22RE

What do they replace in a reman? Just contacts,...

What do they replace in a reman? Just contacts, spring & bearing and then clean the windings/magnet? I guess if Denso does the reman, they will use a Denso bearing. Wonder what bearing a local...
05-21-2019, 12:28 PM
Replies: 10
Views: 2,169
Posted By Paul22RE

I used R&W cooper gasket spray on the 2 timing...

I used R&W cooper gasket spray on the 2 timing chain cover gaskets & RTV for the water pump gasket. There is one bolt for the oil pump that also requires RTV. I think most here will tell you to put...
05-21-2019, 11:30 AM
Replies: 7
Views: 3,073
Posted By Paul22RE

Loosen that bottom bolt holding the pulley arm,...

Loosen that bottom bolt holding the pulley arm, looks like it may rotate or slide down to loosen the tension.
05-20-2019, 06:16 PM
Replies: 7
Views: 3,073
Posted By Paul22RE

Does the compressor have a slot for movement on...

Does the compressor have a slot for movement on the other bolt that holds it on that you can't see in the photo? Might just have to loosen both bolts that hold the compressor and rotate it to loosen...
05-20-2019, 05:42 AM
Replies: 3
Views: 314
Posted By Paul22RE

Looks like 89-92 used the same motor. There are...

Looks like 89-92 used the same motor. There are 2 part numbers that fit, one says "cold spec". Not sure what the difference is between the regular one and cold spec?

windshield wiper motor...
05-17-2019, 09:37 AM
Replies: 7
Views: 441
Posted By Paul22RE

Old brake hoses can collapse, especially after...

Old brake hoses can collapse, especially after getting hot which doesn't allow fluid to flow back after you release the pedal. Change the hose.
05-17-2019, 07:27 AM
Replies: 4
Views: 370
Posted By Paul22RE

There were custom cab or maybe called "extra cab"...

There were custom cab or maybe called "extra cab" pickups that were done at authorized local shops and then sold new by the dealer from about 86-88:
...
05-15-2019, 11:34 AM
Replies: 2
Views: 411
Posted By Paul22RE

I used this company to buy all 4 sizes that cover...

I used this company to buy all 4 sizes that cover every vacuum hose on our trucks. They are quality vacuum hoses from across the pond, was worth the extra few days to ship. Sizes that cover...
05-12-2019, 07:14 AM
Replies: 5
Views: 1,359
Posted By Paul22RE

So 1992 and later 22REs w/a manual tranny are...

So 1992 and later 22REs w/a manual tranny are wired correctly?
05-09-2019, 06:43 AM
Replies: 2
Views: 480
Posted By Paul22RE

https://cimg4.ibsrv.net/gimg/www.yotatech.com-vbul...

https://cimg4.ibsrv.net/gimg/www.yotatech.com-vbulletin/2000x1124/20190509_103954_bafaac514aac30eef3b2407d1ae6a4127a083682.jpg
05-07-2019, 11:24 AM
Replies: 7
Views: 399
Posted By Paul22RE

Looks like you can get a new speedometer head for...

Looks like you can get a new speedometer head for the base model (w/o tach). Part # 83110-35170


https://toyotaparts.bochtoyotasouth.com/oem-parts/toyota-speedometer-head-8311035170
05-07-2019, 10:59 AM
Replies: 7
Views: 399
Posted By Paul22RE

SR5/DLX (with tach) is part# 83010-35580. Not...

SR5/DLX (with tach) is part# 83010-35580. Not avail from dealers, looks like $100-200 for used ones.
05-03-2019, 11:29 AM
Replies: 17
Views: 903
Posted By Paul22RE

For those who do have bolts with worn out caps,...

For those who do have bolts with worn out caps, this co will send 2 free samples. Please don't abuse it. The dude pulling the same thing from the shelf a hundred times in a month might get...
Showing results 1 to 25 of 211
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.