YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: snippits
Showing results 1 to 25 of 235
Search took 0.01 seconds.
06-15-2019, 04:46 AM
Replies: 11
Views: 521
Posted By snippits

Did you buy a Denso TPS or another brand?

Did you buy a Denso TPS or another brand?
06-14-2019, 07:01 AM
Replies: 11
Views: 457
Posted By snippits

Definitely test the ignition switch. It's in the...

Definitely test the ignition switch. It's in the spark test flow chart. Get somebody to wiggle the switch with the key switched to on, and see if you get random no voltage at the coil positive...
06-14-2019, 06:32 AM
Replies: 11
Views: 457
Posted By snippits

Not sure you have a wiring problem or not, so I...

Not sure you have a wiring problem or not, so I am going to throw this out there.

Have you tested the distributor? They do wear out.

Pull the cap off, and remove the rotor. Grab the shaft,...
06-10-2019, 06:29 AM
Replies: 6
Views: 938
Posted By snippits

Distributor cap and shaft o-rings. I think the...

Distributor cap and shaft o-rings. I think the full gasket kit has the shaft o-ring.

https://22reperformance.com/22re-ignition/distributor-shaft-o-ring-and-cap-o-ring

Intake manifold coolant...
06-09-2019, 01:07 PM
Replies: 6
Views: 938
Posted By snippits

Throttle body/IAC plus bypass hoses way cheaper...

Throttle body/IAC plus bypass hoses way cheaper than Toyota.

https://www.amazon.com/gp/product/B000C2W9YQ/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1
...
06-08-2019, 07:38 PM
Replies: 45
Views: 2,385
Posted By snippits

Gremlins! Are you revving the engine any...

Gremlins!

Are you revving the engine any during the time it's idling? If you are, the EGR valve could be sticking. Remove the vacuum hose to EGR, and plug or pinch it closed, and then see what...
06-08-2019, 07:14 PM
Replies: 6
Views: 938
Posted By snippits

I have a 92 pickup. I bought an Enginetech...

I have a 92 pickup. I bought an Enginetech cylinder head complete with cam for $250 shipped from RockAuto. It's been on there 21 months now with round about 17,000 miles or so on it. Still working...
06-08-2019, 07:58 AM
Replies: 5
Views: 647
Posted By snippits

Re-lube the caliper slider pins. Don't use any...

Re-lube the caliper slider pins. Don't use any grease with petroleum because it makes the rubber boots swell and causes sticking.
06-08-2019, 07:49 AM
Replies: 45
Views: 2,385
Posted By snippits

Super easy to take the pair out of the equation....

Super easy to take the pair out of the equation. Just disconnect the fresh air side, and then cap it off. That way all the air is going to the AFM instead of being puffed through the PAIR.
06-08-2019, 07:16 AM
Replies: 7
Views: 684
Posted By snippits

Look at the add a leaf kits. Never used one...

Look at the add a leaf kits. Never used one myself.
06-06-2019, 05:00 PM
Replies: 18
Views: 975
Posted By snippits

Yes I meant to say let the throttle slam closed....

Yes I meant to say let the throttle slam closed. Open the hood, and work the throttle by hand. It will probably sound more like a muffled popping sound.
06-06-2019, 04:51 PM
Replies: 18
Views: 975
Posted By snippits

Do you hear any popping sound from the...

Do you hear any popping sound from the plenum/intake while sitting still revving the engine say to 2500 rpm's, and then let the throttle slam?
06-06-2019, 01:36 PM
Replies: 31
Views: 1,619
Posted By snippits

Sorry, I can't agree with your reasoning. It's...

Sorry, I can't agree with your reasoning. It's like hey you. You own an old car, so you have to pay more to drive on the same roads that I do. And it does not do a dam thing for emissions. It's...
06-06-2019, 12:37 PM
Replies: 31
Views: 1,619
Posted By snippits

Charging people extra this and that for owning an...

Charging people extra this and that for owning an old car is ridiculous. I am sure there would be a lot of push back. All it takes is one judge to shoot it down.
06-06-2019, 12:02 PM
Replies: 31
Views: 1,619
Posted By snippits

Read an article about the state of Georgia...

Read an article about the state of Georgia emission testing, and they said fifty something percent of the testing stations machines were out of spec.
06-06-2019, 10:19 AM
Replies: 31
Views: 1,619
Posted By snippits

Yes because air quality is actually going up.

Yes because air quality is actually going up.
06-06-2019, 06:01 AM
Replies: 31
Views: 1,619
Posted By snippits

I would not worry about it. Emissions testing is...

I would not worry about it. Emissions testing is slowly going away. Here in NC 26 counties are now exempt from smog testing. My 92 pickup was exempt anyway. OBD2 equipped vehicles still have to have...
06-02-2019, 03:54 AM
Replies: 3
Views: 1,070
Posted By snippits

Home Depot keeps it in stock. A fifty foot roll...

Home Depot keeps it in stock. A fifty foot roll costs around $5. Look in the roofing supplies for butyl rubber sealant tape.
06-01-2019, 08:39 AM
Replies: 17
Views: 1,577
Posted By snippits

I can tell you for a fact that the starter...

I can tell you for a fact that the starter testing machines are not 100% reliable. 2009 Honda Civic starter showed good on the machine at Advance Auto. I had already checked everything, and I knew it...
05-31-2019, 06:33 PM
Replies: 17
Views: 1,577
Posted By snippits

Don't think new Toyota factory starters are...

Don't think new Toyota factory starters are available. Toyota does sell reman.

I had to replace my starter on my 92 pickup recently because the bearings were bad. Was cranking the engine over, but...
05-30-2019, 10:06 AM
Replies: 9
Views: 1,646
Posted By snippits

Re-stab the distributor. As it drops in the hole,...

Re-stab the distributor. As it drops in the hole, the rotor will rotate counter clock wise. Easy to mess up on these engines. Set timing with light.

https://www.youtube.com/watch?v=9qEQMzHZtMo
05-28-2019, 05:18 AM
Replies: 21
Views: 2,292
Posted By snippits

That's exactly how I installed mine using a pry...

That's exactly how I installed mine using a pry bar. I did wrap the pry bar with a couple shop rags.

One thing that helps too is if you slightly rotate the cam gear clockwise which tightens up the...
05-28-2019, 04:54 AM
Replies: 21
Views: 2,292
Posted By snippits

You don't need to do that. My cam gear is...

You don't need to do that.

My cam gear is solid. You can still zip tie it. Might have to put a few zip ties together. Just pull the zip tie ends with pliers, so that they are good and tight. ...
05-24-2019, 01:12 PM
Replies: 2
Views: 1,575
Posted By snippits

Yup my 92 has 195-14 on the door jamb. 195 or...

Yup my 92 has 195-14 on the door jamb. 195 or 205 which ever is cheaper. I have 205 15 tires mounted on Mustang wheels on my pickup.
05-24-2019, 09:57 AM
Replies: 8
Views: 2,044
Posted By snippits

It's fixed yay! Bought a Carquest reman from...

It's fixed yay! Bought a Carquest reman from Advance with lifetime warranty. After using a 25% discount code, and a $5 Speed Perks reward my cost was $44.93 total.

I got the 1.0 kW version...
Showing results 1 to 25 of 235
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.