YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: Co_94_PU
Showing results 1 to 25 of 498
Search took 0.03 seconds.
06-13-2019, 08:45 PM
Replies: 11
Views: 457
Posted By Co_94_PU

https://cimg8.ibsrv.net/gimg/www.yotatech.com-vbul...

https://cimg8.ibsrv.net/gimg/www.yotatech.com-vbulletin/640x432/fuelpump_9b5c6c44fb1d5faa6e3bcdb9d0843467d42f85d6.jpg
You can see here the few paths to ground from FC
06-13-2019, 08:43 PM
Replies: 11
Views: 457
Posted By Co_94_PU

If I read this correctly, you check the harness...

If I read this correctly, you check the harness resistance with it completely unplugged and found no shorts? 99% of the time this is going to mean it's good with a slight chance that the short is due...
06-13-2019, 04:10 PM
Replies: 6
Views: 733
Posted By Co_94_PU

Ok so to convert the square to the clipped corner...

Ok so to convert the square to the clipped corner connection.

First you need your volt meter, and second a nine volt battery, and finally some masking tape and something to write with.

Looking...
06-12-2019, 05:13 PM
Replies: 6
Views: 733
Posted By Co_94_PU

Be more specific. Are you trying to figure...

Be more specific.

Are you trying to figure out the vehicles harness or the stereo?

Does your stereo not have the plugs shown above?
06-11-2019, 04:44 PM
Replies: 6
Views: 754
Posted By Co_94_PU

You need to get quantifiable (numbers) on the...

You need to get quantifiable (numbers) on the temperature, the dash mounted guage doesn't give you good enough data. You maybe running the wrong temp guage sender for it, for example there are two...
06-11-2019, 04:18 PM
Replies: 4
Views: 541
Posted By Co_94_PU

If you use the servicing tool there shouldn't be...

If you use the servicing tool there shouldn't be any force trying to tip the engine and stand over.

Without the SST you want to put your wrench handle vertical between the feet of the stand. If...
06-11-2019, 04:10 PM
Replies: 10
Views: 2,157
Posted By Co_94_PU

You need a smaller torque wrench for some of this...

You need a smaller torque wrench for some of this stuff, look for a 1/4 inch drive one that measures in inch pounds. Iirc it's about 7-9 ft/lb which converts to about 100 inch pounds.

Torque...
06-10-2019, 01:14 PM
Replies: 57
Views: 4,360
Posted By Co_94_PU

Buzzer is the key warning (under/next to steering...

Buzzer is the key warning (under/next to steering column) or possibly a power antenna that's fell thru into the fender well.
06-06-2019, 10:20 AM
Replies: 45
Views: 2,385
Posted By Co_94_PU

The tps adjustment and operation is no that...

The tps adjustment and operation is no that critical, if it's out of range in the table to no make sense it uses the "fail safe" table instead.

Something worth checking is that the socket (female)...
06-06-2019, 07:13 AM
Replies: 45
Views: 2,385
Posted By Co_94_PU

We've seen the armature/switch break or bend in a...

We've seen the armature/switch break or bend in a few of these. Easy enough to check by ear or with a multimeter, connect to the VAFM and see how far you have to push the plate open before it closes...
06-05-2019, 10:30 AM
Replies: 31
Views: 1,619
Posted By Co_94_PU

It is actually even more complicated than "what...

It is actually even more complicated than "what state", all they way down to what county and the registered address of the vehicle will matter.

Best bet is to just go ask your emissions tester...
06-03-2019, 04:25 PM
Replies: 7
Views: 1,109
Posted By Co_94_PU

I do not have the sparkplug thread memorized.. ...

I do not have the sparkplug thread memorized..

Some from memory numbers here, the rte ratio is 9.2 the re ratio something like 11.6 running the hybrid rte pison in an re head gives somewhere...
06-03-2019, 10:12 AM
Replies: 7
Views: 1,109
Posted By Co_94_PU

Can you use a 22RE head in a 22RET yes, but you...

Can you use a 22RE head in a 22RET yes, but you probably shouldn't. The turbo version has a larger combustion chamber, less compression ratio.

Wether you choose to use a helicoil or change the...
06-03-2019, 04:47 AM
Replies: 3
Views: 1,269
Posted By Co_94_PU

Do you want the engine to stall and take the...

Do you want the engine to stall and take the power steering out at a very inconvenient moment when you might need it the most??

It is there for a reason, I would suggest not altering the system...
06-01-2019, 09:41 AM
Replies: 3
Views: 1,070
Posted By Co_94_PU

You'll find this sealant in the bits and pieces...

You'll find this sealant in the bits and pieces repair section of the local auto parts franchise, it's the same stuff that hold the vapor barrier under your door panels and is sold in a multipack of...
Replies: 10
Views: 1,957
Posted By Co_94_PU

Your local auto body supply establishment is an...

Your local auto body supply establishment is an invaluable resource, for knowledge as well as supplies.

Toyota reference changed his domain but you can't find your color codes there. Combined with...
05-26-2019, 08:29 PM
Replies: 25
Views: 2,517
Posted By Co_94_PU

I was pretty sure there was enough play n the...

I was pretty sure there was enough play n the springs to slip them (rocker arms) off to the side to replace the seals on the 22r series..

???
05-25-2019, 11:08 PM
Replies: 17
Views: 2,694
Posted By Co_94_PU

With out looking at "the good book" (FSM) I am...

With out looking at "the good book" (FSM) I am pretty certain there will be a spec for the clutch fork play but it's going to be something you need a feeler gauge for not your eyeballs.

My...
Forum: Offroad Tech
05-24-2019, 08:10 PM
Replies: 1
Views: 853
Posted By Co_94_PU

I think you have posted the wrong image? ...

I think you have posted the wrong image?

Your control arm (length) geometry doesn't change such that they no longer hold the axel centered on the frame with this kind of lift kit. You get the same...
05-23-2019, 11:01 AM
Replies: 8
Views: 2,044
Posted By Co_94_PU

If you live in a cold climate the extra...

If you live in a cold climate the extra performance is good peice of mind.

If you have a manual transmission and use the starter for crawling out of a bad spot on an off-road trail, again good...
05-21-2019, 08:16 PM
Replies: 10
Views: 2,157
Posted By Co_94_PU

The previous post has a good point, technics are...

The previous post has a good point, technics are paramount.. A little goes a long way.

If you have an OEM or good quality gasket, speaking of say the lower intake for example, you'll find a...
05-20-2019, 08:29 PM
Replies: 6
Views: 500
Posted By Co_94_PU

Test for short to ground at the taillight...

Test for short to ground at the taillight assembly (reverse lights), and/or the reverse light switch on the transmission.

Figure out that that monstrosity of a fuse panel is doing there in the...
05-20-2019, 08:14 PM
Replies: 6
Views: 609
Posted By Co_94_PU

A: disconnect the quick connect taps (blue) ...

A: disconnect the quick connect taps (blue)

B: never connect them again

C: push your vafm plug all the way in (its not fully seated)

D: come back if it still doesn't run.
05-20-2019, 07:30 AM
Replies: 21
Views: 2,292
Posted By Co_94_PU

Since you cam sprocket is solid you won't be able...

Since you cam sprocket is solid you won't be able to leave it attached to the chain. Use a paint marker to put match marks on the chain and sprocket. Use a load of bungee to attach the chain to the...
05-19-2019, 06:59 AM
Replies: 25
Views: 862
Posted By Co_94_PU

This isn't the product I mentioned. The...

This isn't the product I mentioned. The non-drying type is ment for transferring contact points, IE paint on to part A place part B against part A and you can, for example, now see where to drill...
Showing results 1 to 25 of 498
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.