YotaTech Forums - Search Results

Notices
 
Search: Posts Made By: Co_94_PU
Showing results 1 to 25 of 83
Search took 0.01 seconds.
06-13-2019, 04:10 PM
Replies: 6
Views: 731
Posted By Co_94_PU

Ok so to convert the square to the clipped corner...

Ok so to convert the square to the clipped corner connection.

First you need your volt meter, and second a nine volt battery, and finally some masking tape and something to write with.

Looking...
06-05-2019, 10:30 AM
Replies: 31
Views: 1,613
Posted By Co_94_PU

It is actually even more complicated than "what...

It is actually even more complicated than "what state", all they way down to what county and the registered address of the vehicle will matter.

Best bet is to just go ask your emissions tester...
06-03-2019, 04:47 AM
Replies: 3
Views: 1,262
Posted By Co_94_PU

Do you want the engine to stall and take the...

Do you want the engine to stall and take the power steering out at a very inconvenient moment when you might need it the most??

It is there for a reason, I would suggest not altering the system...
05-21-2019, 08:16 PM
Replies: 10
Views: 2,149
Posted By Co_94_PU

The previous post has a good point, technics are...

The previous post has a good point, technics are paramount.. A little goes a long way.

If you have an OEM or good quality gasket, speaking of say the lower intake for example, you'll find a...
05-20-2019, 08:29 PM
Replies: 6
Views: 500
Posted By Co_94_PU

Test for short to ground at the taillight...

Test for short to ground at the taillight assembly (reverse lights), and/or the reverse light switch on the transmission.

Figure out that that monstrosity of a fuse panel is doing there in the...
05-17-2019, 08:15 PM
Replies: 5
Views: 405
Posted By Co_94_PU

Runs briefly after doing a repair, classic sign...

Runs briefly after doing a repair, classic sign of forgot to plug the vafm back in.
05-16-2019, 12:44 PM
Replies: 15
Views: 786
Posted By Co_94_PU

Aren't vacuum and pressure interchangeable in...

Aren't vacuum and pressure interchangeable in this case?

I'd probably tackle the electrical first and see if I could get the AC amplifier (AC brain) to activate the clutch wire. It needs an RPM...
05-16-2019, 07:25 AM
Replies: 38
Views: 1,406
Posted By Co_94_PU

Looking forward to the autopsy on this one. Like...

Looking forward to the autopsy on this one. Like was mentioned, it was damaged when you got it fortunately it didn't throw a rod thru the block when you were trying to drive it home.

That much of...
05-16-2019, 04:50 AM
Replies: 25
Views: 862
Posted By Co_94_PU

Don't guess! Test! Your local shop...

Don't guess! Test!

Your local shop (Fastenal, for example) has machinist bluing compound (Blue dykem) you can paint this onto the crank shaft and key then place the balancer against it (might need...
05-15-2019, 01:14 PM
Replies: 38
Views: 1,406
Posted By Co_94_PU

Cam versus Ignition, timing

There is a lot of talk about ignition timing going on here. Which I think is a wild goose chase.

There might have been some hints at the beginning indicating a "timing issue", we need to always be...
05-09-2019, 08:06 AM
Replies: 3
Views: 415
Posted By Co_94_PU

Never noticed any seam sealer on mine, how...

Never noticed any seam sealer on mine, how certain are you that you didn't miss some bolt. Behind the door, under the trim, and near the bumper brackets are a few I can think of.
05-06-2019, 03:24 PM
Replies: 11
Views: 630
Posted By Co_94_PU

Well I obviously need to get a reprinted...

Well I obviously need to get a reprinted sticker..
https://cimg4.ibsrv.net/gimg/www.yotatech.com-vbulletin/1500x2000/img_20190506_171632_81576a46ea021d29b0a2a1428971e9f95a81baad.jpg

Tool this...
05-05-2019, 07:24 PM
Replies: 21
Views: 1,149
Posted By Co_94_PU

0.00085 to 0.0015 20° to 170° Let's call...

0.00085 to 0.0015
20° to 170°

Let's call it double the resistance, which ups the current draw about 50%.. It's a CMOS circuit so voltage range is 3.5-5volts.. So if you're following along and...
05-05-2019, 01:13 PM
Replies: 21
Views: 1,149
Posted By Co_94_PU

That really isn't how wire insulation works....

That really isn't how wire insulation works. Having exposed wire in a system is never a good thing, more so when it is an ignition trigger line.

..

Above i left out a bit..running a compression...
05-02-2019, 03:07 PM
Replies: 20
Views: 1,081
Posted By Co_94_PU

You will want to cycle the steering from steering...

You will want to cycle the steering from steering stop to steering stop regardless, this is the bleed/purging procedure. There is a substantial amount of fluid in that line which means when you put...
04-24-2019, 10:42 AM
Replies: 1
Views: 284
Posted By Co_94_PU

I wouldn't fully open the throttle plate, its not...

I wouldn't fully open the throttle plate, its not a modern ECM with a "clear flood" mode triggered by putting the pedal to the floor and then cranking it over. This could give you too much air for...
04-22-2019, 07:43 PM
Replies: 4
Sos
Views: 452
Posted By Co_94_PU

What is required is simple. Lots of cash to...

What is required is simple.

Lots of cash to drop it in the lap of someone willing to do it.

Or lots of time to understand both systems and engineer a process to mate them..


Bottom line all...
04-22-2019, 04:01 PM
Replies: 22
Views: 1,226
Posted By Co_94_PU

Ok I am pretty sure that's atleast twice someone...

Ok I am pretty sure that's atleast twice someone has said something similar to "have it machined.." Or "Have it milled.." and not said anything about having it inspected..

Does it cost more to...
Forum: Items Wanted
04-22-2019, 04:11 AM
Replies: 5
Views: 830
Posted By Co_94_PU

If you poke around you'll likely find even the...

If you poke around you'll likely find even the guys that upgraded to the ct26 are still using these.

Have you considered rebuilding it or brazing the holes closed?
04-17-2019, 06:57 PM
Replies: 10
Views: 977
Posted By Co_94_PU

Cost cutting engineering at its finest.. Two...

Cost cutting engineering at its finest.. Two dollar part removed from five hundred vehicles.. I just saved the company a million dollars, where is my bonus check?

...

I snapped the stalk way...
04-14-2019, 07:20 AM
Replies: 22
Views: 14,248
Posted By Co_94_PU

He connected the primary efi ground (thick wire)...

He connected the primary efi ground (thick wire) to the lower intake is what I am reading.. (Which BTW shouldn't have had any effect on the dash)

Clean up the ground in the kickpanel, fiddle with...
04-11-2019, 01:07 PM
Replies: 9
Views: 616
Posted By Co_94_PU

Your emissions computer is going to register rich...

Your emissions computer is going to register rich with out the extra air which is going to effect your mileage probably more than the pump uses.
04-11-2019, 10:55 AM
Replies: 9
Views: 616
Posted By Co_94_PU

It's function is to pump fresh air into the...

It's function is to pump fresh air into the exhaust, it's just an air pump, the newer models use what is essentially a venturi pump.

Yeah you can disable it but we are all wondering why you would...
04-10-2019, 06:36 PM
Replies: 10
Views: 560
Posted By Co_94_PU

There are two basic types of stop leak (magic in...

There are two basic types of stop leak (magic in a bottle). One being particulates intended to lodge in the leak, the other is a seal conditioner to rehabilitate dry or damaged seals. The first one...
04-05-2019, 10:39 AM
Replies: 20
Views: 1,081
Posted By Co_94_PU

Agree, it is a fused cable like those used to...

Agree, it is a fused cable like those used to supply a high-power audio amplifier. The inner positive cable you should be able to trace into the cabin somewhere. I can see it routes under the...
Showing results 1 to 25 of 83
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.