revenantdead

what was the over all cost for raw material? less the por15 i know that stuff is pricy.

Bandit Runner

Just the steel would run you $100-$200. Depends on if you can find scraps and good deals.

cruisertom

Looks very sharp, you have to stop by so I can see it.

revenantdead

200 i can deal with, 300 even. 900 or better for an out o'the box type i have a bit of a hard time with, ya know?

trex300

I too was wondering if you had any drawings with dimensions and measurments? Also wondering if you had made up a material list. Love your design and work.

Bandit Runner

You are in luck. I have been selling the plans for this and the front bumper.

Here is the sale thread:
https://www.yotatech.com/forums/f109...runner-285949/

PM me with your email address, and I can send you some more information.

Yotard

You do great work. When I was looking to build my front bumper I wanted to model it after yours but I got lazy and just bought the CBI kit for my 95. I really wished I had a third gen just for these bumpers. Are you going to do a swing arm at all for this?

Bandit Runner

Thanks. Yeah, I'll probably design a swing out tire carrier when I get a chance.

Qbert

Dude! that rear bumper is fantastic. You do great work, any chance that this design will work for a 2nd generation 4 Runner? more specifically 1992?
you must have tons of patience.

Bandit Runner

Thanks. But sorry, 3rd gens only.

Bandit Runner

Guys, I'm selling the designs for this and other bumpers. See this thread:
https://www.yotatech.com/forums/f109...runner-285949/

PM me if you are interested.

Thanks.