jimjamn92

bolted to rear end added one cross member to the front and just a small one in the back. but ran out of wire. go figure!
after just doing random things on it was looking around garage and found some pvc pipe so decided to throw snorkel on for ˟˟˟˟s and giggles. ˟˟˟˟ty phone pics!

thebeeler

Looks like you have found a new method for doing the 63in Chevy swap lol

jimjamn92

oh ya changing springs is to much work. i thought frame swap would be easier lol

jimjamn92

also have a 2000lb winch that im going to install on front hopefully tomorow. im excited to possibly go wheeling this sunday. ill definetly throw some pics of it in action if i can get it out.

jimjamn92

just one of the many trails in my are ctually a decent trail shizzy camera lolhttp://youtu.be/VmCQ13t3R6A

jimjamn92

body set on frame and all together! need to weld up some more cross members and make a cross member mount for drive shaft. im finishing welding saturday so ill try and get some pics of that up too. plans for wheeling on sunday are a big 10 4!!!!

jimjamn92

jimjamn92

well snow been killing me i got my frame welded pretty good need to put some more plate. i i have decided since my drive shaft has that coupler bearing on it. i think its cause its an extended cab. but im goin to cut it out take a tube an weld to my driveshaft making it solid. just found out my buddy has some 37 tsl for me for 100$. wandering about front turning clearence with stock ifs. i dont have front fenders and i dont have a bed on the back some im not worried about clearence there. just wandering if any guys seen 37's on stock ifs and what they had to do to clear them turning wise?

jimjamn92

poser pic. got some doors mached up on it. just need to start making bed and flip rear springs

Co_94_PU

iTrader: (-1)

Nice pic did you craw that up there with just the front drive or push it

Not sure about the tires rubbing, worst case you can adjust or fab new turn stops it won't have the factory turn radius but it'll keep you from forgetting and turning too sharply.

jimjamn92

nott gonna lie did a lil 4mph roll to hop it up there lol. gotta weld up a rear drive shaft and ill be able to crawl right up. gotta mount the rear 33's. i think ima wait for the 37's. cause i still have stock gears in it still. ill buy em and just hold on to them till i upgrade to better gears. i was suprised i didnt rub at all when i put 33's on

jimjamn92

driveshaft held up after welding it. thank god. it was pretty sloppy when i went out from all the people that were out wheeling. frame welds and crossmember welds held up great. the day went pretty good wheeling wise until i got a few beers in me and tried this nasty hole. but all in all im glad the thing held for the beating i gave it

andy4x4

haha looks good