1st gen longbed parts: will cut + ship
 

If anyone needs any part of this bed for patching up parts of theirs, I can cut out a section for you. I might need a tiny amount of metal off it for my replacement bed.

I can take more photos and tell you more about areas you might want. All I want is a few bucks for the cutting, packing, and shipping. At least the shipping. I want what good areas are left of it to go to a good home. Fender flares are good, gas door is good, though I might want it to convert to a locking door. I have a tailgate that is just barely a tailgate. It worked for me to secure everything I own in the back and locked up for a cross country move, but it isn't really fixable. It is good for all the internal latching and locking mechanisms and I have 2 sets of bed latch plates of someone wants the guts.

Attachment 115508

Attachment 115509

Attachment 115510

Attachment 115511

Attachment 115512

Attachment 115513

Attachment 115514

Howdy, I'm looking for flares, tailgate guts and handle/latch/studs/etc basically everything found on the gate and the box to do with the gate, hinges, straps, fuel door.
Also need a section of bed floor, the rear passenger side from wheel well to gate post. I'm up in BC though, where are you located?

I have a set of fender flares, the bed is gone, so no sections of floor are available. The tailgate is also gone, but i have some of the hardware.

Thanks, PM sent.

Here are some more photos of the flares.

https://cimg1.ibsrv.net/gimg/www.yot...061e368727.jpg


https://cimg2.ibsrv.net/gimg/www.yot...d3afa6fd8c.jpg


https://cimg3.ibsrv.net/gimg/www.yot...1f2614452b.jpg