3VZE/automatic to 3VZE/manual swap issues?
#1
Registered User
Thread Starter
Join Date: Jun 2013
Location: Prescott Valley, AZ
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
3VZE/automatic to 3VZE/manual swap issues?
Couldn't find much info on this so I'm looking for some answers here.
I have a 1991 4runner 3.0 manual with a dead engine
I found a 1995 4runner 3.0 engine but it has an automatic.
I want to take the 95 engine and drop it in the 91 but I am concerned about any differences that might prohibit that. Is the crank set up the same between the manuals and automatics or am I looking at issues with the pilot bearing set up? Are there differences with the wiring harnesses? I know the fly wheel would need to be swapped too. Is there any other problems or difficulties with making that swap?
From what I did find it sounds like the OBD-I system would be the same on both. Is that correct?
Thanks!
I have a 1991 4runner 3.0 manual with a dead engine
I found a 1995 4runner 3.0 engine but it has an automatic.
I want to take the 95 engine and drop it in the 91 but I am concerned about any differences that might prohibit that. Is the crank set up the same between the manuals and automatics or am I looking at issues with the pilot bearing set up? Are there differences with the wiring harnesses? I know the fly wheel would need to be swapped too. Is there any other problems or difficulties with making that swap?
From what I did find it sounds like the OBD-I system would be the same on both. Is that correct?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM