Wiring diagram needed. 1990-1994 pickup or 4Runner.
#3
I am trying to repurpose the switch. This one has one yellow, one red, one white/green and one white wire. I am trying to figure out how it is wired to send current to the instrument cluster.
#4
Registered User
Join Date: Sep 2007
Location: San Francisco East Bay
Posts: 8,254
Likes: 0
Received 822 Likes
on
649 Posts
That's what a multimeter is for.
I'm almost certain that the switch contains an incandescent bulb. I would expect to find one pair of wires with low (but not zero) resistance for the bulb, and another pair that goes from open to short as you activate the switch.
But I could be wrong about the bulb. The switch could be SPDT, or DPST. Your multimeter will tell all.
I don't have the EWD that shows the connector to that switch, though.
I'm almost certain that the switch contains an incandescent bulb. I would expect to find one pair of wires with low (but not zero) resistance for the bulb, and another pair that goes from open to short as you activate the switch.
But I could be wrong about the bulb. The switch could be SPDT, or DPST. Your multimeter will tell all.
I don't have the EWD that shows the connector to that switch, though.
Last edited by scope103; 09-12-2018 at 05:25 AM.
#6
I have tried it every combination but the right with a multimeter. I am just stuck. I can get it to turn the pwr (orange) light on in the instrument cluster thru the switch but not the green light. I want both to work.
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Dawgz
95.5-2004 Tacomas & 96-2002 4Runners
4
08-12-2023 04:04 PM
toystoplay
General Electrical & Lighting Related Topics
2
05-04-2011 12:46 PM