Sherman Bed sides (sold through Rock Auto) anyone used them ?
#1
Sherman Bed sides (sold through Rock Auto) anyone used them ?
The bedsides on my truck are not particularly rusted, but the previous owner was challenged in avoiding obstacles apparently.... Initially I didn't think there was replacement sheet metal out there, but then I found this: http://www.rockauto.com/catalog/moreinfo.php?pk=1419488
So, compared to paying someone to straighten out sheet metal, this seems like one would get to the end faster by replacing the entire panel ? Any gotchas in there ? Not having see the panel, I can't tell exactly where the old panel gets chopped.
The bed in my truck is not the first priority, but since i will be putting in a new hood, front and rear bumper, tailgate, grill etc it would be nice to get the bed fixed...
Feedback appreciated
So, compared to paying someone to straighten out sheet metal, this seems like one would get to the end faster by replacing the entire panel ? Any gotchas in there ? Not having see the panel, I can't tell exactly where the old panel gets chopped.
The bed in my truck is not the first priority, but since i will be putting in a new hood, front and rear bumper, tailgate, grill etc it would be nice to get the bed fixed...
Feedback appreciated
Last edited by KeithO; 04-12-2010 at 05:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
FS[SouthEast]: Mercury Villager Fan & DCC Fan Controller
coryc85
Misc Stuff (Vehicle Related)
6
09-09-2015 06:24 AM
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
FS[NorAtl]: 1989 pickup beds and leer cap Rhode island
mickyd9990
Misc Stuff (Vehicle Related)
0
07-06-2015 09:01 AM