Question about brake caliper pistons
#1
Registered User
Thread Starter
Join Date: Aug 2002
Location: Washington State
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
Question about brake caliper pistons
All, I'm rebuilding the front calipers on my '91 4wd because a couple pistons in one of them were seized up, and I had to beat the snot out of them to get them out. Each caliper has 4 pistons.
I ordered a couple replacements, and they are just under .1" longer than what came out. If I put them both on the same side of the piston, do you think this size difference will be a problem. I think it will be okay, but I am far from an expert and would like other opinions.
Thanks.
I ordered a couple replacements, and they are just under .1" longer than what came out. If I put them both on the same side of the piston, do you think this size difference will be a problem. I think it will be okay, but I am far from an expert and would like other opinions.
Thanks.
#3
Registered User
Thread Starter
Join Date: Aug 2002
Location: Washington State
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
No, didn't need to go over size. Ordered direct replacements, and this is what I got. I only ordered 2, because all the rest were in fine shape.
Thread
Thread Starter
Forum
Replies
Last Post
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
FS[GreatLakes]: Toyota collection part out
88sasturbotoy
Axles - Suspensions - Tires - Wheels
2
08-11-2015 01:56 AM