Help I am having problems with my Clutch!!
#1
Registered User
Thread Starter
Join Date: Oct 2004
Location: Midland TX
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Help I am having problems with my Clutch!!
Is there any one out there that has done a 4.3 non vortec engine swap and used a stock 5 Toyota 5 speed Trans?
I am having problems with my clutch, it is not disengaging. I bought a slave cylinder with a smaller bore to obtain more throw but it is not enough I need about 1/8” to ¼” more throw.
Is there a way to bleed the clutch master cylinder maybe there is some air in it. I got all the air out of the slave cylinder so I don’t know what else to do.
Does anybody know of a different Clutch master cylinder or any other way I may be able to get more throw out of my slave cylinder?
I bought all my stuff from Advanced Adapters but yet they can’t tell me why I am having this problem.
Hopefully I am not the only person that has had this problem.
Thanks for everything
J.D.
I am having problems with my clutch, it is not disengaging. I bought a slave cylinder with a smaller bore to obtain more throw but it is not enough I need about 1/8” to ¼” more throw.
Is there a way to bleed the clutch master cylinder maybe there is some air in it. I got all the air out of the slave cylinder so I don’t know what else to do.
Does anybody know of a different Clutch master cylinder or any other way I may be able to get more throw out of my slave cylinder?
I bought all my stuff from Advanced Adapters but yet they can’t tell me why I am having this problem.
Hopefully I am not the only person that has had this problem.
Thanks for everything
J.D.
#4
Contributing Member
If you still have the factory clutch and mastercylinder you can adjust it from inside the cab. There should be a nut and a flange that connect to youre clutch pedal. if you get them loose you can adjust it out or on depending on the desired result.
#5
Registered User
Thread Starter
Join Date: Oct 2004
Location: Midland TX
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
It is a factory Clutch master cylinder but the slave cylinder is out of a land cruiser and the clutch and pressure plate is a center force stage 2.
#6
i forget where it is.. but there is some modification you can do to the internal plunger of the master cyl to give mroe throw... it has been said this cures the throw ailment...
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
6
07-16-2015 06:20 AM